Remote Bottle Opener
PART NUMBER 00-66000 and 00-66000-K
I N S T A L L A T I O N I N S T R U C T I O N S
W W W . N I T R O U S O U T L E T . C O M / I N S T A L L A T I O N - G U I D E S
N I T R O U S O U T L E T | 3 0 5 S O U T H 2 8 T H S T R E E T | W A C O , T X 7 6 7 1 0 | P : 2 5 4 - 8 4 8 - 4 3 0 0 | W W W. N I T R O U S O U T L E T. C O M
IMPORTANT- ALL APPROPRIATE SAFETY EQUIPMENT (GLOVES, TOOLS ETC.) MUST BE USED DURING THE INSTALLATION OF THIS PRODUCT(S). NITRO DAVE’S LLC ACCEPTS NO
RESPONSIBILITY FOR INJURIES RESULTING IN THE INSTALLATION OF ANY PRODUCT(S). NITROUS OXIDE IS FOR OFF-ROAD USE ONLY.
©N2O013020
I N S T A L L A T I O N I N S T R U C T I O N S
This Nitrous Outlet Remote Bottle Opener is designed to provide an easy way to remotely open and close your Nitrous Outlet Bottle. This item is compatible
only with the Nitrous Outlet Billet High Flow Valve. If this opener is for the Nitrous Outlet X-Series Bottle Valve, you will need an adapter (P/N 00-66000-sleeve).
If you need any assistance during installation or if you have questions about this item, call our Tech Help Line at (254) 848-4300.
Tools Needed for Installation*:
• 1/2” Wrench
• Drill
• 13/16” Drill Bit • Wire Crimper
• 3/16” Allen Wrench
• Ratchet
Parts List:
• Billet Housing with Motor Collar
• Collar Bolt Gear • Rubber Grommet • Thumb Screw
• 6 x Mini Push-On Terminal
• Mini Rocker Momentary Switch
• 2 Wire Weather Pack Connector
• Red Butt Connector
•Red Ring Wire End
• Yellow Butt Connector
• Yellow Ring Wire End
• Washer
*These are the tools required for installation of this kit on a stock vehicle. If your vehicle has aftermarket parts, other tools may be required.
Step 1:
Remove the plastic cap on top of the bottle valve, and remove
the On/Off knob with a 1/2” socket and ratchet.
Step 2:
Loosen the bolt on the collar with a 3/16” Allen Wrench.
Then, place the collar on top of the bottle valve and ensure
it’s sitting all the way down on the bottle valve. Then, tighten
the collar bolt with a 3/16” Allen Wrench.
***In the event you need the remote opener in a certain orientation, loosen the Collar
and rotate it to the position you need it to be in.***
Step 3:
Place the remote opener gear on the bottle valve, and ensure
it’s completely seated. Then, secure the Remote Opener Gear
using the nut that held the On/Off knob. Tighten it down with
a 1/2” Socket and Ratchet.
