TRANSIT Entry Quick Reference
2007-06-11
Part no : ???????
This information is furnished for guidance, and with no guarantee as to its accuracy or completeness; its publication conveys no license
under any patent or other right, nor does the publisher assume liability for any consequence of its use; specifications and availability of
goods mentioned in it are subject to change without notice; it is not to be reproduced in any way, in whole or in part, without the written
consent of the publisher.
SAFETY PRECAUTIONS
The following safety precautions should be observed during normal use, service and repair.
•
The TRANSIT Entry must be connected with safety ground.
•
The TRANSIT Entry may only be installed and serviced by qualified service personnel.
•
Disconnect the power supply before removing or installing any parts.
•
To be sure of safety, do not modify or add anything to the TRANSIT Entry other than mentioned
in this installation guide or indicated by NEDAP N.V.
Step 1 Mounting instructions
The TRANSIT Entry can be mounted to any surface, even directly onto metal. Locate an appropriate
position. Use the enclosed mounting drawing to drill appropriate upper two keyholes (K) to mount the
reader. Open the service cover to secure the reader using the two lower mounting positions (L). See
the mounting sketch for more information.
L
service cover
K
200mm (7.87"
)
47mm (1.85")
220m
m (
8
.6
6
")
108mm (4.25")
35m
m
171m
m (
6
.7
3
")
(1
.38
")
63mm (2.48")
4.5mm (.17")
∅
5mm
(.20")
∅
4.5mm
(.17")
rear view
front view
side view
Step 2 Opening the service cover
Open the screws on the bottom of the TRANSIT Entry to
unlock the service cover. Once the service cover is unlocked,
lift it off.
Make sure the screws are completely opened (and closed
when replacing the cover). Don’t worry about losing the
screws, they cannot fall out.
Figure 1: Service cover TRANSIT Entry
Note: Make sure the screws are completely opened (and closed when placing the cover back on). Don’t
worry about losing the screws, they cannot fall out.
