![background image](http://html1.mh-extra.com/html/navitar/nuview-490mcl1625/nuview-490mcl1625_installation-instructions_3911907001.webp)
Installation of Navitar Series 490 lens on Sony VPL-FE40 & FX40
projectors
.
TOOLS REQUIRED: Metric Phillips head screwdriver (magnetic)
Disassembly:
1. Disconnect unit from power source.
2. Place a piece of cardboard on the working surface and turn the projector upside
down and lay it on its top on the cardboard to keep from scratching the top side of the
projector. Make sure that the prime lens is pointed toward you.
3. Remove the (2) projector legs located at the front of the projector.
4. Loosen the three screws holding the lamp cover with a Phillips head screw driver and
remove the cover by pulling it toward you and out of its tabs. The screws will remain
captured with the cover.
5. Use the Phillips head screw driver to remove the screws holding the lower section
and the top of the projector together. Their location is marked with a raised arrow
including one of the screws on the controls side of the projector. Put the screws in a
safe location.
6. Grasp the projector with both hands in order to keep the upper and lower half
together and turn the projector right side up.
7. Gently lift the bottom of the projector at the front and pry it open just enough to allow
your hand to reach inside.
8. Reach inside and disconnect the small white cable located farthest to the left from the
circuit board by pulling it toward you. This will allow you to separate the cover from
the bottom of the projector. Remove the cover and set it aside.
9. Remove the prime lens from the projector by pushing the plastic lever to the right of
the lens toward the lens and lifting it upward at the same time until the lens is
released. Pull the lens straight out toward you to disengage the electrical connector.
Assembly:
1. Rotate the adapter flange assembly and separate it from the lens.
2. Place the adapter flange assembly inside the projector with the longer tube facing
towards the front of the projector.
3. The notch for the handle will be located on the upper right side and the slot for the
pin on the same side. Line up the flange to fit over the pins inside the projector.