Current as of 2016-05-11
26321
TTL Flash Trigger for Canon
Instruction Manual
F
OREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recognize the requirements
of professional as well as amateur underwater photographers and fulfill them
through the innovative designs of our products. We strive to achieve a high
level of user-friendliness by allowing stress-free installation and easy
operation of all important functions of the camera.
Please read this manual carefully before using the product, this will maximize
its performance as well as its lifetime.
W
ARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for consumer
use.
This warranty only applies to products purchased from authorized
NAUTICAM dealers and does not extend beyond the original retail purchaser.
To return your product for service, please contact your regional authorized
service center(s). Please note that this warranty only applies when the product
is purchased in the territory where the service center is located.
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the inability
to capture images even if it is due to the malfunctioning of our products.
Unauthorized modifications and/or repairs of our products will automatically
invalidate the warranty.
P
RECAUTIONS
•
Use only batteries approved for use in this product, do not mix old and new
batteries.
•
Check the battery terminals before installing into the product.
•
Remove batteries for storage, do not store the product in an environment
of high humidity.
•
Do not leave the product in direct sunlight for prolonged periods.
•
Keep out of reach of children, failure to do so could result in injury.
•
Defective products should be shipped to our distributors for service,
unauthorized disassembling and/or modifications could result in mal-
function.
I
DENTIFICATION OF
P
ARTS
B
ATTERIES
I
NSTALLATION
Press and slide the battery compartment cover and open it as shown by the
arrows.
Install the battery. Make sure the +ve and –ve terminals are correctly oriented.
Then return the cover to its original position.
C
ONNECT TO THE
C
AMERA
CAUTION: Be sure to turn off the flash trigger before attaching or detaching.
Slip the flash trigger’s hotshoe connector into the camera’s hotshoe until it
cannot goes any further.
To remove the flash trigger, press and hold the release button and slide it out
from the camera.
--- continue on next page ---
On/off button and power lamp
Release button
Battery compartment cover
Locking pin
Flash head
Indicator
Press and hold
Slide
Hotshoe connector
Press
1
2
