®
MT 1 MEDIA TUNER
Mounting Instructions
MOUNTING INSTRUCTIONS FOR THE C 375BEE
The MT 1 is compatible with C 375BEE. Using the supplied flexible flat cable
(FFC), DC power connector and screws, the MT 1 can be installed in a C 375BEE
by undertaking the following procedure.
Note that if the C 375BEE has a PP375 Phono Preamplifier Module already
installed, the MT 1 and the PP375 can be linked together using the other
supplied FFC.
STEP 1
Pre-install the requisite cables to their respective connector points on the MT 1
as shown. Connect the FFC to the MT 1’s PHONO port only if the C375BEE has a
PP375 already installed.
STEP 2
Make the following connections:
1
DC POWER connector from MT 1 to corresponding P216B in C375BEE’s main
board.
2
FFC from MT 1’s ANALOG OUT to P213B on C375BEE’s main board.
3
If the optional PP375 module is installed: FFC from MT 1’s PHONO port to
the corresponding FPC (flexible printed circuit) connector of the PP375
module.
Ensure good harnessing by flexing and safely contorting the FFC and
DC POWER connectors.
STEP 3
Remove the dummy cover at the back of the C375BEE and install in its place the
MT 1. Use the supplied screws to fix into place the MT 1.
3
2
1
IMPORTANT!
The MT 1 is only compatible with C 375BEE units that have the
0.5W standby
logo on their rear panels.
