background image

Illustration

Location of controls

2 Band Alarm
Clock Radio

28037

OPERATING INSTRUCTIONS

Electrical requirements

Check the voltage on the rating plate of your clock radio corresponds with

your house electricity supply which must be A.C. (Alternating current).

For clock radios with a fitted plug.

If the socket outlets in your home are not suitable for the plug supplied with

this appliance the plug should be removed and the appropriate one fitted.

IMPORTANT : THE PLUG REMOVED FROM THE MAINS LEAD, IF SEVERED,

MUST BE DESTROYED AS A PLUG WITH A BARED FLEXIBLE CORD IS
HAZARDOUS IF ENGAGED INTO A LIVE SOCKET OUTLET.

Should the fuse in the 13 amp plug require changing a 3 amp BS1362  fuse

must be fitted.

Battery back-up facility 

(unit will work without a battery being fitted)

Your alarm clock radio is equipped with a battery back-up facility.

1 Remove the battery compartment cover (located underneath the unit) by

pushing in the clip and lifting off.

2 Insert a battery size 9 volts PP3/6LR61 (Ensure batteries are inserted correctly)
3 Replace the battery compartment cover.

Should a power interruption occur the clock will continue to run, however, time
keeping will not be accurate. The display will be extinguished to conserve battery
life but the memory will retain details of the clock time and alarm settings.

If the optional battery is not installed in case of the AC power failure the display
will blink to indicate the power was interrupted. You will need to reset the clock
and alarm.

Battery back-up is designed to operate for a short period only.

If the unit is not to be used for a prolonged period, remove the battery to
avoid battery leakage.

In the interests of environmental safety : dispose of batteries safely.

P.2

P.3

P.4

9

Clock display

10 Minute button
11 Snooze button
12 Alarm indicator
13 PM indicator
14 Time button
15 Sleep button
16 Battery compartment

(underneath unit)

1

Function selector switch

2

Volume control

3

Band selector

4

Tuning control

5

FM wire aerial

6

Speaker

7

Alarm button

8

Hour button

Switching on, and setting the clock time

Before any alarm functions can be used on your alarm clock radio you
must first set the clock to the correct time.

1 Place the unit on a flat surface. Plug the mains plug into the wall socket and

switch on the wall socket.

2 The 

clock LED display

 will flash.

3 Press and hold the 

TIME  button

 and simultaneously hold down the hour

button or the minute button. The 

LED clock display

 will fast forward the

minutes and hour segments. Release all buttons when the correct
time is set.

4 The PM indicator will illuminate to indicate 12.00 midday has been reached.

Radio operation

FM wire aerial

To obtain the maximum FM reception fully extend the wire FM aerial (which is
located at the rear of the unit) and alter the direction of the wire for best results.

The aerial for the MW waveband is located inside the unit. To obtain the
maximum MW reception rotate the clock radio.

1 Slide the 

FUNCTION SELECTOR

 

switch

 to the ‘ON’ position.

2 Adjust the 

VOLUME control

 to a suitable level.

3 Set the 

BAND SELECTOR switch

 to either MW or FM as desired.

4 Slowly adjust the 

TUNING control

 to select your desired station.

5 To switch off  the radio, slide the 

FUNCTION SELECTOR switch

 to the

‘OFF’ position.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

Reviews: