A
B
1
4
3
2
IMPORTANT
OR
ANT/IN
POWER OPTIONS:
Connect one end of the 30 ft. Coaxial
Cable to the connector on the antenna
(see illustration below) and connect the
other end of the coaxial cable to the
power injector.
Note: Excessive cable length may cause reception
loss.
Connect the coaxial cable from the power
injector to the ANT/IN connector on the
back of the TV.
Sandwich the mast between the
bottom and top toothed
brackets and secure with the
included wingnuts.
Insert the short end of the mast
into the mounting bracket.
Use the two carriage bolts and
washers to secure the mast to
the mounting bracket.
Place the U-bolt under the
bottom toothed plate, and
secure the plate to the antenna
with the 4 included screws and
washers.
- Make sure there is another person present (on the ground) while
installing the antenna.
- DO NOT attempt to mount the antenna on a windy, rainy, or
snowy day.
If you intend to mount the antenna on a rooftop, make sure to
mount it at least 20 ft. away from any power lines or utility poles.
Continued
INSTRUCTIONS
30 ft.
Coaxial Cable
Power Injector
[email protected] 1.877.825.5572 www.gomohu.com
If you have any difficulties with the installation of your antenna, please contact Mohu®.
Si tiene alguna dificultad instalando su antena, por favor contacte a Mohu®.
II
II
Mounting Bracket
Mast
The power injector must be powered in
order to function. Plug the power
injector’s USB cable into an open USB
port on the back of the TV.
If the TV does not have a USB port, use
the included USB power adapter with any
standard 120V wall outlet.
Note: If using an RF
splitter, follow the RF
splitter installation
instructions on the
back of this page.
FIRSTSTAGE AMPLIFIED INDOOR / OUTDOOR HDTV ANTENNA
Select mounting location;
ideally wood framework
indoors (in attic) or outdoors
(roof/siding).
Sail Antenna
Power Injector
USB Power Adapter*
30 ft. Coaxial Cable
*Actual USB power adapter may differ in appearance.
Antenna Mounting Hardware
x4 - Screws
x4 - Washers
x4 - Outdoor Screws
x2 - Wing Nuts
x1 - U-Bolt
x2 - Carriage Bolts
x2 - Flange Nuts
Two and Four-Hole
Antenna Mounting Brackets
and Teeth
FOLLOW ALL SAFETY PROCEDURES, WARNINGS, AND
INSTRUCTIONS WHEN INSTALLING YOUR ANTENNA.
MOUNT THE ANTENNA AT LEAST 20 FT. FROM ALL
POWER LINES OR UTILITY POLES.
SAFETY PROCEDURES
POWER LINE WARNING
Position the mounting bracket
(flat surface to wood) to create
an “ ” shape when viewed from
straight on.
Secure the mounting bracket by
using the four large outdoor
screws.
USB Cable (attached)
Back of TV
Coaxial
Cable
(attached)
a. TV's USB Port
b. Wall Outlet
BOX INCLUDES
