RDIS SERIES
Installation Instructions
MOBERN LIGHTING
8200 Stayton Dr., Suite 500 | Jessup, MD 20794 | Phone: 800.444.9288 Fax: 301.953.9310 | www.mobern.com
• For information on how to recycle LED/Fluorescent electronic products, please visit
www.epa.gov
•
Do not install damaged product. This fixture is properly packed to prevent damage
during transit.
• All wiring connections should be capped with UL approved recognized wire
connectors.
• Do not touch LED diodes or any connecting clips; these parts are very sensitive.
•
Do not exceeed maximum wattage marked on fixture label.
Carefully read the instructions pertaining to your fixture
thoroughly. IF YOU HAVE ANY QUESTIONS REGARDING
THE PROPER INSTALLATION OR LOCAL CODES,
CONSULT A QUALIFIED ELECTRICIAN.
Injury to persons and damage to the fixture and/or
mounting surface may occur if the fixture is pulled from the
surface. To reduce risk of injury or damage, mount only to
a mechanically sound surface.
Both cord set and hard wired fixtures are intended for
connection to a grounded, three wire source of supply.
Install and wire the fixture in locations in accordance with
all national, state and local codes.
Do not install outdoors or in applications other than
intended use.
To avoid shock hazard, do not work with live electrical
wires.
Ensure fixture is properly grounded before testing.
This fixture is intended for dry applications only.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTIONS AND
OPERATIONS OF THE PRODUCT AND THE HAZARDS INVOLVED.
RISK OF FIRE; MINIMUM OF 90°C SUPPLY CONDUCTOR SHOULD BE USED.
CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR.
TO AVOID ELECTRIC SHOCK HAZARD, DISCONNECT THE POWER AT THE PANEL
BOARD (CIRCUIT BREAKER BOX) BEFORE BEGINNING INSTALLATION.
TO AVOID FIRE HAZARD RISK, WHEN INSTALLING HARD WIRED UNITS, BE AWARE
IF SUPPLY WIRES ARE LOCATED WITHIN THREE INCHES OF BALLAST. IF SO, USE
WIRE RATED FOR AT LEAST 90°C (194°F). IF UNSURE, CONSULT A QUALIFIED
ELECTRICIAN BEFORE INSTALLING.
