7 Line
Fold Down Clothesline
MCL13046
2 x Wall Brackets
2 x Front Bars
Contents
Your carton should contain the following parts:
2 x Side Arms (assembled)
1 x Front Brace
1 x Accessories Bag
1 x Line Cord
Wall
Bracket
Line Cord
Telescopic
Strut
Side Arm
Front Bar
Front Brace
Line
Tensioner
- Tape Measure
- Timber or Masonry Drill Bits
- Pencil
Required
Tools
- Drill / Hammer drill (ideal)
- Spanner
Optional
- Spirit Level
- Hack Saw (if shortening width)
The recommended mounting height of the top slotted hole in the wall bracket is:
USERS 10cm.
Minimum height is 160cm.
Choosing a Suitable Location
Installation and Assembly
If you are using a Milkcan Ground Mount Kit, skip steps 1 & 2 and refer to instructions inside the ground mount kit packaging.
1. Mark position of wall brackets to an overall width of 240cm between centres. If your required width is less than 240cm, please refer to
Reducing the Overall Width below.
3.0
www.milkcan.com.au
(03) 9464 6964
56 Northgate Drive,
Thomastown VIC 3043
20cm
20cm
Reducing the Overall Width
If your available space doesn’t allow the full 240cm
width, you can reduce the width of your Clothesline as
follows:
- For this example, we are assuming your required
overall width is 200cm. This is a total reduction of
40cm.
- Cut half from each side of the 2 x cross bar
segments i.e. 40 / 2 = 20cm each side
The cuts will be
covered by the
cross brace
