See www.routerboard.com for more information. Contact [email protected] for support questions.
3-Jun-14
Quick Setup Guide and Warranty Information
First use
•
Connect antenna cables to the built in Wi-‐Fi connectors
•
Device accepts 10-‐30V with a passive PoE powered Ethernet cable or with a power connector to the Power Jack
Powering
The board accepts power with the following modes:
•
With PoE to Ether1 port. It accepts 10-‐30V DC input (at the board; higher voltage needed to compensate for power
loss on long cables; at least 18V suggested) from non-‐standard (passive) Power over Ethernet injectors (no power
over data lines). The board
does not
work with IEEE802.3af compliant 48V power injectors.
•
Direct input to the power jack 10-‐30V (select models only)
Booting process
RouterOS is the operating system of all RouterBOARD routers. Please see detailed configuration guide here:
http://wiki.mikrotik.com/wiki/Category:Manual
This device doesn't come fitted with a Serial Port connector, so initial connection has to be done via the Ethernet cable, using
the MikroTik Winbox utility. Winbox should be used to connect to the default IP address of
192.168.88.1
with the username
admin
and
no password
.
In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button of the de-‐
vice when starting it until the LED light turns off, and Groove will start to look for Netinstall servers.
In case IP connection is not available, Winbox can also be used to connect to the MAC address of the device. More infor-‐
mation here:
http://wiki.mikrotik.com/wiki/First_time_startup
Extension Slots and Ports
•
One Ethernet port
(With Auto MDI/X so you can use either straight or cross-‐over cables for connecting to
other network devices). The Ethernet port accepts 10-‐30V DC powering from a passive PoE injector. Built-‐in
802.11ac WiFi card
with two MMCX
connectors.
Buttons and Jumpers
•
RouterOS reset jumper hole (Reset2 in above image) – resets RouterOS software to defaults. Must short circuit the
metallic sides of the hole (with a screwdriver, for example) and boot the device. Hold screwdriver in place until
RouterOS configuration is cleared.
911 Lite5 ac
RouterBOARD 911 Lite5 ac comes with built in 802.11ac dual chain wireless device and one Ethernet port.
•
Reset button (Reset1 in above image)
– Holding this button during boot time will make the RouterBOARD look for
Netinstall servers. Release the button after the LED light goes out.
