LHG 60 series
The LHG 60 is an outdoor wireless router with a built in directional antenna which works in the 60GHz spectrum. It can be used
as a CPE to connect to MikroTik devices that work in 60GHz access point mode.
Assembly
Attach the two legs to the LHG case, then snap the assembled LHG unit to the grid in the appropriate locations. Fix the legs in
place with two self thread screws (Included, use Phillips screw driver PH2). The package also contains a grounding cable
connector and a precision alignment mount. Alignment instructions available on the product page on
https://mikrotik.com/products/
Connecting
1.
Open the ethernet door to connect an ethernet cable to the ethernet port, connect the other end of the ethernet cable
to the included PoE injector (LHG Lite60), or a 802.3af/at power source (supported only by the LHG 60G model).
2.
Plug the PoE injector into your network switch or ISP internet outlet.
3.
Plug the included power supply into the PoE injector to start up the device.
4.
For configuration purposes, set your computer IP configuration to static in the range of 192.168.88.0-254 (/24 or
255.255.255.0)
5.
Default IP address of the unit is 192.168.88.3/24, open this address in your web browser to start configuration. The
username is admin and there is no password.
The device is preconfigured as a w60g station, and all you need to do is select the AP to connect to and set a device password.
You can do this in the quickSET tab that is loaded by default. In case IP connection is not available, Winbox can be used to
connect to the MAC address of the device. We recommend clicking the “Check for updates” button and updating your RouterOS
software to the latest version to ensure the best performance and stability.
In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button of the device
when starting it, until the LED light turns off, then the device will start to look for Netinstall servers.
More information about using RouterOS and connecting to this device in our documentation: http://mt.lv/help
Powering
The LHG Lite60 only accepts 12-30 V power from Passive PoE injectors (one power supply and PoE injector are included). The
LHG 60G accepts 12-57 V 802.3af/at powering and also Passive PoE. Both models can consume up to 5 W at maximum load.
Extension Slots and Ports
One ethernet (10/100 Mbit or Gigabit, depends on model), supporting automatic cross/straight cable correction (Auto
MDI/X), so you can use either straight or cross-over cables for connecting to other network devices.
One Integrated w60g interface with built in antenna.
Buttons and Jumpers
RouterBOOT reset button has the following functions. Press the button and apply the power, then:
Release the button when green LED starts flashing, to reset RouterOS configuration to defaults.
Release the button when the LED turns solid green to clear all configuration and defaults.
Release the button after LED is no longer lit (~20 seconds) to cause device to look for Netinstall servers (required for
reinstalling RouterOS over network).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power
is applied to the device. Useful for RouterBOOT debugging and recovery.
See www.mikrotik.com for more information or contact
