1
ANI-F Maxon
Multi-Format ANI Encoder
Manual Revision: 04-08-25
Covers Software Revisions:
ANI-F: 1.0
SPECIFICATIONS
Operating Voltage
9.8 VDC
Operating Current
2.6 mA
Operating Temperature
-30 - +60 C
Frequency Range
280-3600 Hz
Audio Output Level
1 V (RMS)
Audio Output Impedance
22 K
Ω
PTT Output Current
200 mA
Tone Distortion
<1%
ABOUT THE ANI-F
The ANI-F offers ANI & Emergency ANI encoding
tone signaling formats such as Motorola’s MDC-
1200 & MDC-600, M/A-Com’s G-Star, DTMF, 5-
tone, 2-tone, ANI with Status, or Burst Tone. A
special POCSAG paging version is also available.
The ANI-F can be used with Midian’s CAD or DDU
Series products for monitoring ANI and ENI
transmissions.
PRODUCT PROGRAMMING
Midian’s ANI-F Maxon is programmed via Midian’s
KL-3 programmer. Please reference the KL-3
manual for setup instructions of the KL-3 software
and hardware. From the product selection screen
on the KL-3 UP software, select the appropriate
product name from the list and click OK.
Set the parameters of the ANI-F Maxon software to
fit the application. If any clarifications on a feature
are required, move the mouse cursor over the
feature name until the question mark appears and
right click, a definition of the feature will be shown.
After entering the parameters, save the file by going
to File - Save As. Enter the file name in the File
Name block and click Save. Saving the file will allow
for quick and easy reprogramming of units.
After plugging the board into the radio, but with the
radio still open (see next section), connect the black
lead of the KL-3 to a common ground, the yellow clip
lead to Program Out pad, and the green clip lead to
the Program In pad. Ground the PTT Input, apply
power to the radio and click “Program Unit” in the
KL-3 software. Follow the same procedure to read
the unit, but select “Read Unit” in the menu bar.
HARDWARE INSTALLATION
Be certain to follow standard anti-static procedures
when handling any of Midian’s products.
SP-120/130/140/310/320/330/340/SL-55/55+: Open
the radio, following the instructions detailed in the
Maxon radio manual. The following table lists the
factory settings of the radio links and how they
should be configured for installation of the Midian
board. Once the link positions are correct, plug the
Midian board onto the options connector labeled
CON404, and then reassemble the Maxon radio.
For the SP-300 Series it will be necessary to keep
LK14 out and insert LK19.
LK #
Factory
ANI-F
LK1 Out Out
LK2 In
In
LK3 In
In
LK4 In Out
LK5 In
In
LK6 Out Out
LK7 In
In
LK8 Out Out
LK9 Out Out
LK12 In
In
LK14 Out
In
LK15 Out
Out
LK16 In
In
LK17 Out
Out
LK18 Out
Out
LK19 Out
Out
LK20 Out
Out
LK21 Out
In
LK22 Out
Out
SM-2000 Series & PM-100/160: Open the radio,
following the instructions detailed in the Maxon radio
manual. The following table lists the factory settings
of the radio links and how they should be configured
for installation of the Midian board. Once the link
