MFJ-5124Y3 Radio Interface
Instruction Manual
©
2006 MFJ Enterprises, Inc.
Rev. 12/20/06
Read Instructions Before Operating
The MFJ-5124Y3 interface cable provides proper control between a Yaesu MP-
series radio and the MFJ-991/993/994/991B/993B/994B
IntelliTuner
TM
Automatic Antenna Tuners. Supported Yaesu radios are FT-1000MP, MP
MKV, MP MKV Field and any Yaesu radio compatible with the Yaesu FH-1
Remote Control Keypad.
Connections and Operation
1. Insert the mono end of the cable to the Yaesu radio’s REMOTE jack.
2. Insert the stereo end of the cable to the tuner’s RADIO INTERFACE
jack.
3. Push the [TUNE] button
on the tuner
for 0.5 to 2 seconds to initiate
automatic tuning process. The Yaesu MP-series transceiver
automatically drops to the low-power CW mode and stays in this mode
until tuning of the tuner is complete. See the appropriate Yaesu
manual for setting the low power tune mode.
4. For Yaesu owners who have an FH-1, an inexpensive 1/8” headphone
splitter (mono or stereo) may be used to connect the FH-1 in parallel
with the MFJ-5124Y3.
Technical Assistance
If you have any problem with this unit first check the appropriate section of this
manual. If the manual does not reference your problem or your problem is not
solved by reading the manual you may call
MFJ Technical Service
at 662-323-
0549 or the
MFJ Factory
at 662-323-5869. You will be best helped if you have
your unit, manual and all information on your station handy so you can answer
any questions the technicians may ask.
You can also send questions by mail to MFJ Enterprises, Inc., 300 Industrial
Park Road, Starkville, MS 39759; by facsimile (FAX) to 662-323-6551; or by
email to [email protected]. Send a complete description of your
problem, an explanation of exactly how you are using your unit, and a complete
description of your station, and the unit’s firmware version number.
