Bluetooth Watch User Manual Draft
Watch Firmware v0.7.15
Android APK v0.1.9b
Getting Started
Starting the Watches
Charge your watch. Attaching the clip may cause the watch to reset. This is only for Beta units.
It is due to the Reset pin used for 2-wire JTAG (embedded debugging) being turned ON by
default.
Resetting the watch causes pairing information to be deleted. This (pairing information) will be
stored in Flash memory in the next revision of software. If you reset while paired, be prepared
for a new pairing request.
If you are using a large grey charge clip that has an 18 pin ribbon connector on the back, you
should attach your clip to the watch BEFORE applying power via the micro USB socket.
If you are using the small black clip with only a micro USB socket, then you should be able to
attach to the watch however you like. It may be possible to short the power against the steel
case back; there are protections in place to limit any damage, but you may notice the clip
getting hot if this occurs. Try to verify that everything is seated correctly and that the watch is
charging.
Digital Watch
There are 6 buttons on the digital watch. When booted the digital watch has these functions
(mostly for demonstration and debug). The watch boots in a “radio mode”.
MetaWatch.org
User Manual Draft
APK v0.1.9b
Watch v0.7.15
