How to…
Replace Cardio-Tramp Webbing
Remove
and Replace
1. Remove webbing from
Cardio-Tramp by detaching
all four Velcro strips around
the metal frame.
2. To ensure correct positioning
of replacement webbing, place
webbing on a flat, solid surface
with the logo face-down.
Ensure straps on all four sides
are open with Velcro strips
facing upward.
NOTE: Surface must be strong
and stable enough to support
firm tapping from a rubber
mallet or similar tool.
3. With rounded corners at
top, place metal frame of
Cardio-Tramp on straps of
webbing. Align frame with
middle of each strap.
NOTE: When securing Velcro,
press it together from the middle
outwards, ensuring that ends and
side of Velcro is lined up exactly.
If necessary, remove entire length
of Velcro and reposition until it
lines up exactly. Using a rubber
mallet or similar tool without
sharp edges, strike entire length
of Velcro strip to ensure Velcro
is fully attached, specifically
at the ends.
4. Start by securing bottom edge
of replacement webbing. At the
bottom of the frame, there is a
square rod and a rounded bar.
Straps should be wrapped over
rounded bar only. Attach Velcro
securely as outlined above.
Step 1
Step 2
Step 3
Step 4
