background image

10" 

WIRELESS

 

RaceScale

#50220

 

Instructions

FOR  FURTHER  TECHNICAL  ASSISTANCE  CONTACT:

TANNER RACING PRODUCTS by MB

10 COOPERATIVE WAY

WRIGHT CITY, MO. 63390

800-467-2464 / 636-745-7757

TannerRacing.com

Frequency Change Instructions

If there is interference with the operation of the scales (ex. much slower operation 

than normal or no operation at all) it may be necessarry to change the frequency. 

This can be done by following these steps.

1.

Set all scale pads out individually (at least 12" apart).

2.

Pivot the hand held antenna until the antenna is perpindicular to the floor (this

is essential for communication between the pads and hand held) and turn the hand

held on by pushing the "ON/OFF" button. DO NOT turn the scale pads on at this

time.

3.

When the menu appears, select "RF Frequency" by pressing the "OK" button.

Give the unit a few seconds to scan the channels and you  will see numbers appear

under "ACTIVITY".  Scroll the arrow down and select the frequency with the low-

est number (least  amount of interference) by pressing "OK". (Typically 903-915

commumicate the fastest.)

4.

Turn the hand held off by pushing the "ON/OFF" button for 2  seconds.

5.

Turn the scale pads on by switching the battery switch on each  scale pad to

"ON" and press the reset button on the front of the black box.(Green light will start

blinking indicating power is on.)

6.

Turn the hand held back on by pushing the "ON/OFF" button.

7.

When the menu appears, select "Weigh Vehicle" by pressing the "OK" button.

Give the hand held 2 minutes to start communication with the scale pads. When the

red lights on ALL scale pads are blinking and numbers appear on the scaling screen

the frequency has been changed and the scales are ready to use. If you find that one

scale does not blink red after 2 minutes, simply turn that scale off and back on and

press the reset button.

   Hand Held 

Battery Charger

Communications

         Cable

  Hand Held

Scale Display

Reviews: