This model heater features an exclusive,
replaceable heating element system
(patent pending). In the event that a
heating element in this heater should
break, burn-out or become inefficient,
you can purchase replacement elements.
To find the nearest location of a retailer
who sells Marvin
®
Replacement Heating
Elements (Part # E1750), call our
Customer Service Dept. Toll-Free
between
9:00 a.m. and 5:00 p.m. EST for
assistance:
1-800-733-1706.
REPLACING
ELEMENTS:
1. Open Guard
Remove screw located at the bottom
center portion of the guard. This will
allow the guard to swing open.
2. Remove old element
Grasp element near the side of the heater
opposite the switch. Push the element
towards the switch-side of the heater with
enough pressure to allow the other end of
the element to disengage from its socket.
3. Install new element
Insert either end of the element into the
socket located on the switch-side of the
heater. Push the element far enough into
this socket to allow the other end of the
element to be inserted into its socket.
4. Close Guard and
re-install screw.
REPLACEABLE
HEATING
ELEMENTS
Congratulations!
On becoming a new
Marvin
®
Heater owner.
Marvin manufactures high
quality, safe, electric
heaters designed to
provide years of trouble
free service. Our heaters
are made right here in
Urbana, Ohio. Many of
our employees are second
or third generation, and all
of them are dedicated to
giving you the finest
heaters in the world.
We want you to be
satisfied with your new
Marvin Heater. All of our
heaters are tested at the
factory before shipping to
insure quality.
Should you have any
problem, please call our
Customer Service
Department toll-free at
1-800-733-1706. Your call
will receive prompt and
courteous attention.
We appreciate your
comments about our
products and look forward
to hearing from you.
Thanks again for
choosing Marvin.
Sincerely,
Angus Randolph,
President
W.B. Marvin
Manufacturing
Company
797060-2(-)-0703
MODEL 7060
WORKZONE OVERHEAD
WORKSHOP HEATER
INSTRUCTION MANUAL
WARRANTY INFORMATION
UNDERWRITERS
LABORATORIES
LISTED
Made in the U.S.A.
W.B. Marvin Manufacturing Company
211 Glenn Avenue,
Urbana, Ohio 43078-0230
937-653-7131, Fax 937-652-1375
Toll-Free: 1-800-733-1706
www.wbmarvin.com
When using electrical appliances, basic
precautions should always be followed to
reduce the risk of fire, electric shock, and
injury to persons, including the following:
1.
Read all instructions before using
this heater.
2.
This heater is hot when in use. To
avoid burns, do not let bare skin touch hot
surfaces. If provided, use handles when
moving this heater. Keep combustible
materials, such as furniture, pillows,
bedding, papers, clothes, and curtains at
least 3 feet (0.9m) from the front of the
heater and keep them away from the sides
and rear.
3.
Extreme caution is necessary when
any heater is used by or near children or
invalids and whenever the heater is left
operating and unattended.
4.
Always unplug heater when not in use.
5.
Do not operate any heater with a
damaged cord or plug or after the heater
malfunctions, has been dropped or
damaged in any manner. Return heater to
W.B. Marvin Manufacturing Co. for
examination, electrical or mechanical
adjustment, or repair. (See the section “For
Repairs” on the back cover)
6.
Do not use outdoors.
7.
This heater is not intended for use in
bathrooms, laundry areas and similar
indoor locations. Never locate heater where
it may fall into a bathtub or other water
container.
8.
Do not run cord under carpeting. Do
not cover cord with throw rugs, runners, or
the like. Arrange cord away from traffic area
and where it will not be tripped over.
9.
To disconnect heater, turn controls to
off, then remove plug from outlet.
10. Connect to properly grounded
outlet only.
11. Do not insert or allow foreign objects to
enter any ventilation or exhaust opening as
this may cause an electric shock or fire, or
damage the heater.
12. To prevent a possible fire, do not block
air intakes or exhaust in any manner. Do not
use on soft surfaces, like a bed, where
openings may become blocked.
13. A heater has hot and arcing or sparking
parts inside. Do not use it in areas where
gasoline, paint, or flammable liquids are
used or stored.
14. Use this heater only as described in
this manual. Any other use not
recommended by the manufacturer may
cause fire, electric shock, or injury to
persons.
15. Avoid the use of an extension cord
because the extension cord may overheat
and cause a risk of fire. However, if you have
to use an extension cord, the cord shall be
No. 14 AWG minimum size and rated not
less than 1875 watts.
16. The wire guard is an important safety
feature and must be securely closed during
operation or for storage. Failure to secure
the grille may result in injury and / or
damage to this unit.
GROUNDED PLUG
For 120 volts. This cord has a
3-prong plug as shown. An adapter
is available for connecting three-prong
grounding-type plugs to two-slot
receptacles. The green grounding lug
extending from the adapter must be
connected to a permanent ground such
as a properly grounded outlet box. The adapter should not
be used if a three-slot grounded receptacle is available.
GROUNDED
3-PRONG
OUTLET
OUTLET WITH
ADAPTOR - SHOWN
CONNECTED TO
METAL SCREW OF
OUTLET BOX
COVER.
GROUNDING
PIN
Do not attempt to service or repair this
heater. If damaged or not functioning
properly, return heater to W.B. Marvin.
For safety reasons, servicing is only
available at the factory.
When returning the heater to us, pack the
heater in its original carton THEN pack that
box in a larger shipping box and pad well.
Ship to:
W.B. Marvin Manufacturing Co.
Inspection Department
211 Glenn Avenue
Urbana, Ohio 43078-0230
For Warranty Repairs
Include proof of purchase and a note
explaining the problem with your heater,
and a return address.
We will repair or replace (at our option)
your heater and return it to you. Please
allow 2 weeks.
For Out-of-Warranty Repairs
Return heater along with a note explaining
the problem with your heater, a phone
number where you can be reached during
the day, and a return address.
We will inspect your heater & call you with
a quote for the cost of repairs.
W.B. Marvin is concerned
about the well being of our
environment, and we’d like to
point out the following:
1. Many components of our products are
made from recyclable materials. And, we
will continue to look for new materials to
help the environment.
2. The use of our heaters encourages
conservation by allowing the user to
conserve on central heating.
3. All shipping cartons are recyclable.
W.B. Marvin is constantly looking for new
ways to help the environment. Please don’t
hesitate to send us your suggestions.
FOR REPAIRS
SINCE 1915
PLEASE READ AND SAVE THESE
IMPORTANT INSTRUCTIONS
1
2
7
W.B.Marvin Manufacturing Co., the
manufacturer, warrants to original
purchasers of their electric heaters that
Marvin heaters shall be free from
electrical defects for a period of three (3)
years (2 years for heating elements) from
the provable date of purchase. The
applicability of any implied warranties is
limited to the same three (3) year (2 years
for heating elements) period. Some states
do not allow limitations on how long an
implied warranty lasts, so the above
limitations may not apply to you. The
manufacturer is not responsible for any
defect or malfunction caused by abuse or
misuse occurring while the heater is in
the possession of the purchaser including
without limitation uses for purposes not
intended by the manufacturer.
The manufacturer is not responsible for
any defect or malfunction caused by
repairs attempted by others, damage in
transit, abusive treatment or commercial
application.
In the event of the occurrence of a defect
covered by this warranty, the original
purchaser shall, at his expense, return the
heater along with proof of purchase to the
manufacturer, attention Inspection
Department. If the defect is covered by
this warranty, the manufacturer shall
within sixty (60) days after receipt thereof
correct the electrical defect without cost
to the original purchaser. Any questions
concerning this warranty shall by directed
to the Inspection Department of the
manufacturer.
This warranty gives you specific legal
rights, and you also may have other
rights which vary from state to state.
The W.B.Marvin
Manufacturing Company
THREE-YEAR
LIMITED WARRANTY
2-YEAR WARRANTY ON HEATING ELEMENTS
Tools Needed for Installation:
Socket Wrench (for swivel mounting)
Phillips Head Screwdriver (for key slot
mounting), Drill with 1/8" Drill Bit
Want to use your new heater
in multiple locations?
Additional Mounting Brackets are
available from W.B.Marvin – Brackets
are $12.95 each including shipping
and handling. Send check to:
W.B. Marvin Co.
7000 Bracket
211 Glenn Avenue
Urbana, Ohio 43078
