K00364 Electronic Bin Thermostat
Installation Instructions
This kit reduces overfill and condensation issues and can be used on any Manitowoc ice machine installed on an ice
dispenser. Order kit number K00336 for the following models IB0620, IB0820, IB1020, QF0400 and QF2300.
Control Settings
Flake/Nugget/Chiplet:
The control must be reset from the factory setting.
Refer to the jumper and control settings.
Ice Cube Machines:
The machines use the factory control settings.
The controller has a one-minute time delay anytime
power is interrupted and restored.
Positioning the Touchpad Jumpers
P5 Jumper
The P5 jumper position determines if the touchpad is
locked or unlocked. The control is factory locked; to
unlock, move the jumper from one pin to two pins.
P4 Jumper
The P4 jumper labeled Jump 1 is used to set the control
for heating or cooling mode. Jump 2 is used to
establish set point at either cut-in or cut-out.
Cubers
Flake/Nugget/Chiplet
Setting Control Set point Value
To view and adjust set point, follow these steps:
A.
Press MENU until the display flashes SP.
B.
Press MENU again to display the existing set
point value.
C.
Press up or down (arrows) to change the set
point value.
D.
Press MENU again to save the new value. The
display returns to the sensed temperature.
E.
If no setup entry is made for 30 seconds, the
control reverts to the normal temperature
display.
IMPORTANT:
If MENU is not pressed after changing the set point
value, the control reverts to the previously
programmed set point value.
RED
SENSOR
LEAD
BLACK
SENSOR
LEAD
JUMPER
LOCATIONS
MATCH
WIRING
TO ICE
MACHINE
VOLTAGE
BIN SWITCH OR
TOGGLE SWITCH
