![background image](http://html.mh-extra.com/html/manitowoc/fs9000/fs9000_instruction-sheet_701365001.webp)
Instruction Sheet
Subject: K00459 - S Model Bin Thermostat Kit
ICE MACHINE ON COKE FS9000 OR FS9100
DISPENSER W/ADAPTER KIT
1 of 5
Document Number: 000013527 Rev02 04/19
MANITOWOC ICE
2110 SOUTH 26TH STREET, MANITOWOC, WI 54220
800
-
545
-
5720
WWW.MANITOWOCICE.COM
n
Warning
Authorized Service Representatives are obligated to
follow industry standard safety procedures, including,
but not limited to, local/national regulations for
disconnection / lock out / tag out procedures for all
utilities including electric, gas, water and steam.
n
Warning
Disconnect electric power to the ice machine and
dispenser at the electric switch box before proceeding.
n
DANGER
Failure to disconnect the power at the main power supply
disconnect could result in serious injury or death. The
power switch DOES NOT disconnect all incoming power .
Two or more people are required to move this equipment
to prevent tipping..
n
Warning
Two or more people are required to move this
equipment to prevent tipping..
This instruction pertains to two dispenser models. Follow
the instructions for the model you are working on either
FS9000 or FS9100.
FS9000 Assembly and Mounting
1. Move the ice machine and dispenser away from the
wall for easier access.
2. Bracket
selection
A.
Dual evaporator ice machines - Use bracket with
the shorter top flange.
B.
Single evaporator ice machines - Use bracket with
the longer top flange.
3. Remove all panels and control box cover from the ice
machine.
4. If an ice machine is already installed on the dispenser:
•
Remove the fasteners securing the ice machine to the
adapter (located on the rear of the dispenser).
•
Raise and support the installation side of the ice
machine.
5. Hook the bracket assembly onto the respective back
spacer flange. Locate bracket assembly as illustrated.
NOTE: Dimension is from the edge of the adapter to the
edge of the bracket.
Single evaporator – 23.00” from right side of adapter.
Dual evaporator – 18.00” from right side of adapter
6. Lower/place ice machine on dispenser and secure ice
machine to adapter with fasteners. It is important to
confirm that the ice maker is slid rearward contacting
the bracket and back spacer flange before re-fastening
(close gap).
23”
Use long flange bracket
Confirm presence of back
spacer flange fastened to
adapter and ice maker
18”
Use short flange bracket
Confirm presence of back spacer
flange & vertical bracket fastened
to adapter and ice maker