MS361
Microwave Motion Sensor
Instruction Manual
Thank you for purchasing the Major Tech MS361 Microwave Motion Sensor
The MS361 uses Microwave technology (5.8GHz) for the sensor
thus detecting even the slightest movement in its detection zone to
turn lighting on and off based on occupancy. The MS361 can be
installed into existing light fittings or in new lights. If installed and
mounted on the ceiling at a height of around 2.5m, the detection range (radius) can be adjusted
to a minimum of 3m and a maximum of 12m. The light can be set to stay on for any period of
time from approximately 10 seconds to a maximum of 12 minutes. Detection is possible to go
through doors, panes of glass or thin walls. Major Tech Microwave Sensor is ideal for home
use and also in educational and commercial properties.
SPECIFICATION:
Power Sourcing: 220 -240V/AC Detection Range: 360°/180
°
Power Frequency: 50Hz Detection Distance: wall::5-15m(adjustable)
Ambient Light: <3-2000LUX (adjustable) Celling:2-8m(radius),adjustable
HF System: 5.8GHz CW radar, ISM band Transmission Power: <0.2mW
Time Delay: Min. 10sec ± 3sec Installation Height: wall:1.5-3.5m
Max.12min ± 1min celling:2-10m
Rated Load: 500W Power Consumption: approx 0.9W
200W Detection Motion Speed: 0.6-1.5m/s
FUNCTION:
➢
Can identify day and night:
The sensor works in the day and at night when it is adjusted
to
the “sun” position (max). The sensor works in ambient light in less than 3LUX when it is
adjusted to
the “moon” position (min). As for the adjustment pattern, please refer to the
testing pattern.
➢
SENS adjustable:
The sensor can be adjusted according to the location. The detection
distance of low sensitivity can be only 2m and for high sensitivity 16m which will be suitable
for a large room.
➢
Time-Delay is added continually:
When it receives the second induction signals within
the first induction, it will restart timing.
➢
Time
–Delay is adjustable.
It can be set ac
cording to the consumer’s requirements. The
minimum time is 10sec ± 3sec. The maximum is 12min ±1min.
NOTE: The high-frequency output of the HF
sensor is <0.2Mw- that is just one 5000
th
of the
transmission
power of a mobile phone or the
output of a microwave oven. Children safe.
INSTALLATION:
(see diagram)
➢
Switch off the power.
➢
Fix the bottom on the selected position with the inflated
screw through the screw holes at the side of the sensor.
➢
Connect the power and the load to the sensor as per the
connection-wire sketch diagram.
➢
Switch on the power and test.
