714-772-5202 FAX 714-772-2302
web: www.majormfg.com
INSTRUCTIONS FOR USE WITH
HIT-136 INSTALLATION TOOL
SARGENT PROFILE SERIES CYLINDRICAL LOCKS
Remove allen bolt and back plate. Place HIT-136 drill guide on door with aligning washers in the
2-1/8” crossbore. HIT-136 should be placed on door so the writing on the front plate is in the
upright position. Replace back plate and tighten allen bolt until snug. Do not over tighten. HIT-136
is now ready to retrofit Sargent Profile Cylindrical Locks. All through bolt holes may be drilled in
one operation through the door, or half way from both sides. This unit was designed to retrofit
locks with 2-3/4” backsets.
DRILLING INSTRUCTIONS
Place alignment washers
on inside of HIT-136 drill
guide in the 2-1/8” lock
crossbore. This is how the
drill guide is aligned.
Tighten the allen bolt with
the supplied wrench, it
needs to be snug. Do not
over tighten.
