Figure 4. Rear Print Cartridge Installation/Removal
5. RUN EXCELLA DEMO
•
Click on the Excella Demo icon to run the demo.
•
The Demo’s main screen will be displayed (see Figure 5 below).
•
In the “Select Device” window, choose the device you want to connect (USB or Ethernet).
•
Click on the “Connect” button.
•
Based on the document you want to read, click on one of these buttons:
o
“Check”, to read and scan checks (the left LED is blinking)
o
“Card”, to read and scan ID cards (the right LED is blinking)
o
“Check/Card”, the unit will accept either a check or a card (both LED’s blinking)
•
Feed the appropriate document.
•
The unit will remain in the Read/Scan mode until the “Stop” button is clicked.
P/N 99875344-2.03 09/06
EXCELLA STX INSTALLATION GUIDE
(RNDIS USB Drivers or Ethernet Only)
1. START
•
For USB, go to Step 2 below
•
For Ethernet, got to Step 3 below
2. USB INSTALLATION
Software Installation
•
Remove earlier versions of the demo using the PC’s
Add or Remove Programs
.
•
Insert Excella STX’s Software & Drivers CD in drive; the CD will run automatically.
•
Follow the wizard instructions to install the software and use the default directories.
•
When prompted by the Wizard, select option (a) and (b) below to install the Excella STX Demo and API;
to skip the Excella STX Demo and only install the API and MagTek USB Drivers, select option (b) only:
(a)
Excella STX Demo and API (Demo requires drivers for USB Devices)
(b)
Excella STX USB Driver and API
•
When done, click on
Finish
to complete the installation process.
•
NOTE:
The default destination folder is
C:\Program Files\MagTek\Excella-STX\
Connect cables
•
Connect interface USB cable to Excella STX (refer to Figure 1 below).
•
Connect round connector from the power supply to Excella.
•
Connect the power cord to the socket on the power supply block.
•
Connect the three-prong power cord
to AC wall outlet.
•
Wait until only the middle LED is illuminated with a steady green.
•
Connect interface cable
to PC.
•
NOTE:
When the device is plugged in and detected by the PC, the USB drivers will be automatically
installed.
Figure 1. Cables & Connectors
Power Cord
Page 4 of 4
Page 1 of 4
