There are many ways to connect your new DVD/VCR to your Television and other equipment.This
Quick-Use Guide shows the easiest, most common connection between the DVD/VCR and a TV.
Higher quality connections are explained in the owner’s manual and will provide better sound or
picture if your TV and/or audio system is compatible.
ANT-IN
ANT-OUT
DVD/VCR
VCR
AUDIO OUT AUDIO IN
L
L
R
R
VIDEO OUT VIDEO IN
COAXIAL
DVD
S-VIDEO
OUT
COMPONENT
VIDEO OUT
Y
L
C
R
AUDIO
OUT
DIGITAL
AUDIO OUT
C
B
R
4
REAR OF TV
(EXAMPLE ONLY)
ANTENNA IN
IN
OUT
RF COAXIAL CABLE
CABLE
TV SIGNAL
ANTENNA or
CABLE TV SIGNAL
CABLE BOX
OR
2
3
1
Disconnect all equipment from the power outlets. Connect the equipment to the power outlets
only after you have finished hooking up everything. Never make or change connections with equipment
connected to the power outlet.
2
If you do not have a Cable Box, simply connect your Antenna or Cable TV signal directly to the
ANT-IN jack on the rear of the DVD/VCR.
If you do have a Cable Box (or Satellite Receiver), first connect the Cable TV (or Satellite) signal
to the IN jack on the Cable Box/Satellite Receiver. Then, use an RF coaxial cable (like the one
supplied) to connect the OUT jack of the Cable Box/Satellite Receiver to the ANT-IN jack on
the DVD/VCR.
3
Connect the supplied black RF coaxial cable to the DVD/VCR’s ANT-OUT jack and to your TV’s
ANTENNA IN jack. The TV’s ANTENNA IN jack could be labelled 75-ohm,TV IN, or RF IN. Check your
TV manual for details.
4
Plug the power cords of the DVD/VCR and the TV into an active power outlet.
5
Turn on the TV power. Set the TV to channel 3. (If you cannot use channel 3 at your TV, you can
use channel 4 instead. However, you must set the DVD/VCR’s output channel to 4. See the accompanying
DVD/VCR owner’s manual for details.)
6
Press the STANDBY-ON
2
button on the DVD/VCR or its remote to turn on the DVD/VCR.
The first time you turn on the DVD/VCR, you should complete the VCR setup. See the other
side of this Quick-Use Guide for details.
Quick-Use Guide
Quick-Use Guide
530VR qug2 19/03/2003 2:49 PM Page 1
