USER MANUAL
M2SW.801
-2-
Table of contents
Warranty
Safety information
Specifications
Product overview
Product inspallation
Adjust the volume
Product care
3
3
3
4
5
6
6
EN
Specifications
MSW.801 play a music from a RCA line input or from a High level
input.
The operating frequency range is from 30Hz to 120Hz. Output rated
power 250 Watt (80W RMS). Signal to noise ratio > 100dB. Input
sensitivity @1% THD: 160mV /RCA and 4.5V/High level. Max current
consumption 10A. Operation voltage from 9Volts to 15.5Volts.
-3-
Warranty
Thank you for purchasing this Macrom product. Should
your product need warranty service, please return it to the
shop where you buy it or to the Macrom distributor in your
country. The warranty does not cover damage due to
improper use and or installation, incorrect connections to
power supply and audio video sources, exposure to excessive
humidity, unauthorized repair attempts or modifications.
Safety information
Before beginning with installation, disconnect the wire from the
battery ground terminal to prevent any short during installation.
This subwoofer must properly installed by Macrom authorized
installer. Impropers installation may damege the unit and /or the
vehicle. Verify all electrical and drivability of the vehicle before the
installation.
Product overview
Power LED indicator
Fuse
-4-
M2SW.801
Power terminals
RCA line Input
Level Input
Frequency cutting
Protection LED indicator
High level Input
Remote level control
Front panel
Power terminals
DC +12 V Battery
Power remote control
Ground/negative
-5-
Connect the power wires to the terminal block, pay attention to
respect cable polarity indicated on the product.
Connect the signal input according to the selected input (RCA method
1) or (High level method 2).
Adjust the frequency cutting and the level input sensitivity.
Place all the knobs in the center position, and start adjusting the gain
and follows the frequency cutting to optimize the best match vehicle
acoustics.
Product installation
RCA line input method 1
High level input method 2
Follow all mounting and wiring instructions to ensure the integrity of
existing wiring after installation.
Separate Audio and Power wiring to avoid interference.
All wires and connection must be insulated with electrical tape,
and fitted with protective connector shields where ever possible.
Before replacing blown Fuse, check and verify that there is not
short at all connections.
Only use 10A fuse in to the unit.
Adjust the Volume
To adjust the volume while listening to music
turn the volume knob from remote level control.
Please remember that excessive sound pressure
can damage the speaker.
Product care
Please remember that your Macrom product is an electronic device,
and so needs to be treated with care:
Do not subject it to mechanical shock or vibrations.
Do not subject it to excessive heat.
Keep it away from water and excessively humid areas.
Keep it away from high electromagnetic fields.
There are no user-serviceable parts inside. Opening the product or try
to repair it will terminate the warranty.
The MACROM brand is a registered trademark of ALDINET S.p.A.
w w w . m a c r o m . i t
ALDINET S.p.A
Viale C. Colombo, 8 - 20090 Trezzano s/N (MI) - Itlaly
Tel. +39 02 484781
Declaration of Conformity
Manuale di istruzioni M2SW801_600 ENG-IT.indd 1
18/09/2013 14:40:05
