MORE INFORMATION
THESE SPECIFICATIONS
ARE AVAILABLE ON 3.5"
PC & MAC FORMAT DISK IN
POPULAR WORD
PROCESSOR FORMATS
■
CALL 800/258-6883
FAX 425/487-4337
OUTSIDE THE U.S., CALL
425/487-4333
2/6/98
4. SPECIFICATIONS.
In
addition to specifications
previously cited, the XLR10
shall meet or exceed the
following performance
criteria: Frequency Response,
20Hz to 40kHz
±
1dB;
Distortion, less than 0.025%,
20Hz-20KHz; Mic Preamp
E.I.N., –129dBm; .
The component shall be a
Mackie Designs XLR10 for
the CR-1604 Mixer.
MIXERMIXER
1. GENERAL CONFIGURA-
TION.
The combiner shall
mix the outputs from up to
three Mackie Designs
CR-1604 mixers (or equiva-
lent) and provide a single set
of combined outputs. The
combiner shall be capable of
being mounted horizontally
or vertically via integral
mounting tabs, or may be
placed on a table. The
combiner shall be entirely
self-contained including
power supply.
2. INPUTS/OUTPUTS.
The
combiner shall have stan-
dard tip/sleeve unbalanced
jacks to accommodate
THREE INPUTS EACH for the
following: AUX 1 through 6,
ALT 3 and ALT 4, Monitor,
stereo headphones (tip=left,
ring=right) and Left and
Right Main Inputs. All inputs
XLR10 EXPANDER
1. GENERAL CONFIGURA-
TION.
The component shall
provide an additional 10
Balanced Microphone Inputs
for the Mackie Designs CR -
1604 16-channel Mic/Line
Mixer. Component shall
attach to the CR-1604,
forming a single, physically
and electronically integrated
component.
2. INPUTS/OUTPUTS.
The
component shall include on
its rear panel, electronically
balanced mic inputs using
female XLR-3-type connec-
tors to accept nominal levels
of from –48dBU to +14dBU.
Each channel shall have a
rotary Sensitivity Control
adjustable from –4dB to
–48dB. There shall be a
phantom power supply with
separate switch to provide
+43/48V DC to all mic input
connectors for remote
powering of condenser
microphones.
3. PHYSICAL CONFIGURA-
TION.
The component shall
be grey-black with alumi-
num/steel chassis, which
shall be mechanically
connected by metal screws
and electronically con-
nected by ribbon cable to
the CR-1604. The XLR10’s
dimensions shall be 2.1" tall
by 17.34" wide (including
screw heads) by 2.6" deep.
XLR10•MIXERMIXER•ROTOPOD•REMOTE FADER
®
