Please read all instructions prior to installation and keep for future reference!
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
1
1.1
Place the fixture on its back, to get access to in the inside. Carefully,
loosen & remove all the Phillips screws along the sides of the modules
labeled
&
. Then pull out the
main power access
mount access
modules from the housing. Modules are secured internally to housing,
with an aircraft cable.
3
1. PRODUCT TO BE INSTALLED BY A QUALIFIED
ELECTRICIAN.
2. MORE THAN ONE PERSON IS RECOMMENDED FOR THIS
INSTALLATION.
3. SUITABLE FOR DRY LOCATIONS
4. CEILING MOUNT ONLY
5. TYPE IC
6. INHERENTLY PROTECTED
mounting channel
screw
wood frame
mounting
channel
flange
3.1
3.1
2.1
Carefully, remove the hex nuts from inside of the housing and then pull
out the mounting channel.
2
3-
7/8
" through 4"
opening
mounting channel
housing
hex nut
2.1
2.1
NOTE: Power wires must be present prior to installing the fixture. Refer to wiring diagrams
on page 4 n addition all fixtures must be mounted to a wood frame with an opening of
. I
3-7/8" - 4" for fixtures to properly be installed.
3.1
Slide the conduit through the mounting channel hole, then align the flange to the
wood frame and secure using the proper screws.
4.1
Install the drywall, leaving an opening in between the mounting channel.
Fixture opening must be at least 3-7/8" - 4'. Clean fixture opening of any
excess compound or debris, for fixture to lay in properly.
4
mounting channel
wood
frame
3.1
4.1
drywall
drywall
1.1
mainpower access
mainpower access
mainpower access
mount access
main power
access module
mount
access module
screw
power conduit
FIXTURE NOT TO SCALE
Page 1 of 6
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
Models TOVE-R-XX
Tove recessed mount
-
Installation Instructions
REV0.2 04132018
