![background image](http://html.mh-extra.com/html/lumex/700175cr/700175cr_assembly-and-operation-instructions_1948392001.webp)
700175CR-INS-LAB-RevB14
1
700175CR UPRISE ONYX FOLDING WALKER:
ASSEMBLY & OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
WARNING: Important! Read and understand these instructions before assembling or using
the UpRise Onyx Folding Walker. If you do not understand any part of these warnings or
instructions, contact a healthcare professional for direction in the use of this product. If the
UpRise Onyx Folding Walker is not properly assembled, personal injury and damage to the
Walker could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT use
substitute parts. Use only Lumex replacement parts. The use of non-Lumex replacement parts
could cause personal injury, property damage, and void the warranty.
WARNING: This product has a maximum weight capacity of 400 lb, EVENLY DISTRIBUTED.
WARNING: Always use caution when using this product on wet or slippery surfaces.
WARNING: Notice for California Customers- California Proposition 65 WARNING: This product
contains a chemical known to the State of California to cause cancer and reproductive or
developmental harm.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury caused
by improper assembly or use of this product.
INTENDED USE
The Lumex 700175CR UpRise Onyx Folding Walker is intended as a dual-purpose mobility aid and rising aid. It is
recommended for use by users whose height is between 5'4" and 6'2". Please consult a healthcare professional for
proper adjustment, as recommended user heights are an approximation.
UNPACKING
Remove walker frame and leg attachments from carton and protective packaging. Check for obvious damage
to the carton or its contents. If damage is evident, do not use the product; please notify the carrier and your
Graham-Field authorized distributor for further instruction.
ASSEMBLY
Install Leg Attachments
1. Depress the leg assembly button and insert the leg
attachment into the leg until the leg assembly button pops
out of its hole on the frame, as shown at right.
2. Repeat for other three legs.
Adjust Walker Height
Handgrip-to-floor height is adjustable between 32" and 39".
Each walker leg is equipped with several height adjustment
positions, as shown at right.
1. To adjust leg height, depress the height adjustment button
and twist the leg attachment to the desired height until the
height adjustment button pops out of the appropriate hole.
2. Repeat for other three legs.
WARNING: Before proceeding, ensure leg assembly
buttons protrude fully from frame holes, height
adjustment buttons protrude fully from height
adjustment holes, and all legs are adjusted to the
same height.
Open Walker (see picture at right)
1. Grasp one handgrip and pull away from center of walker.
2. Repeat with other handgrip.
3. Push handgrips away from each other until the walker release mechanism clicks into place.
Info: You will hear the release mechanism click into place.
4. Walker is properly opened when release mechanism push button is up.
handgrip
secondary
handgrip
release
mechanism
push
button
height
adjustment holes
height
adjustment
button
walker tip
leg
attachment
rear
leg
leg assembly
button
frame
700175CR Lumex UpRise
Onyx Folding Walker