Installation Instructions
1
|
P a g e
v 1 . 0 ( 0 8 / 2 0 1 7 )
EOS II 70MM RGB 4 LIGHT KIT
SKU# 220958
Rated Voltage 220-240V~ 50Hz
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep instructions for future reference.
Warranty
•
This fitting is covered by a 3 year warranty from the date of purchase. Please retain proof of purchase.
•
Warranty will be void if there is any damage due to improper usage or modification to the fitting.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.
•
This is a deck light and not suitable for use in areas such as driveways and concrete pathways where it is difficult
to ensure proper drainage away from the fitting. Installation in these locations will void the warranty.
•
This fitting is not suitable for use with dimmer switches. Warranty will be void if the fitting is used on the same circuit
which has a dimmer switch.
Installation Requirements
•
This fitting is a DIY (Do It Yourself) product, no electrical wiring connection or disconnection is required.
The service of a licensed electrician is not required.
•
This fitting is designed to be used with a mains power socket outlet (not included).
The installation location must have an existing mains power socket outlet (not included) pre-installed.
If you don’t have an existing mains power socket outlet (not included), please contact your licensed electrician.
•
Select a suitable location for installation:
−
This product is suitable for indoor or outdoor use.
−
This fitting is protected against water penetration to IP65 standards, which is jets of water from any direction.
−
This fitting is not designed to be immersed in water. Ensure the fitting is installed in a location where the water
can be easily drained away.
−
The connectors on the light kit are not designed to be immersed in water or installed under any soil or concrete.
Ensure the connectors are positioned in a location where the water can be easily drained away.
−
The power adaptor must be plugged into a socket which is indoors only.
−
The IR RGB receiver is protected against water spray to IP44 standard.
−
This fitting can be used where normally flammable materials, including building insulation, are or maybe present,
but cannot be abutted against any material and cannot be covered in normal use.
−
Take note of the clearance values. Do not remove any structural members for the installation of this product.
RISK OF FIRE – BUILDING INSULATION MUST NOT COVER THIS LUMINAIRE
HCB = 20mm MIC = 20mm SCB = 10mm SCI = 10mm
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all components on a smooth surface and make sure there are no components missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the fitting has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
•
Ensure power to the circuit you are working on has been switched OFF before commencing any electrical work.
