INSTALLATION INSTRUCTIONS
LED RETROFIT KIT FOR FIXTURES WITH (2) T-8 FLUORESCENT LAMPS
LED-3120xxRF Series
•
LED-312022RF
(2) 48” 22 watt lamps
•
LED-312013RF
(2) 36” 13 watt lamps
•
LED-312009RF
(2) 24” 11 watt lamps
TOOLS REQUIRED:
Flat screwdriver, wire cutter/stripper, awl or other pointed tool
CAUTION: Risk of fire or electrical shock. Installation requires knowledge of luminaires electrical systems.
The following procedure is intended to be performed by a qualified electrician. If not qualified, do not attempt
installation. Contact a qualified electrician.
The electrical rating of these products is 120 - 277 VAC.
To prevent wiring damage or abrasion do not expose wiring to edges of sheet metal or other sharp objects.
Luminaires wiring, ballasts or other electrical parts may be damaged when drilling for installation of LED
reflector kit hardware. Check for enclosed wiring and components.
Only those open holes indicated in the drawings may be made or altered as a result of kit installation.
Do not leave any other open holes in an enclosure of wiring of electrical components.
Not for direct replacement of fluorescent lamps.
Do not use where directly exposed to water.
The Retrofit Kit is accepted as a component of a luminaire where the suitability of the combination shall be determined by CSA
or authorities having jurisdiction.
®
KIT INCLUDES:
(2) lamps
(1) label - power end
(1) label - fluorescent warning
1890 Swarthmore Avenue • Lakewood, NJ 08701 • Tel 800-526-3694, 732-363-4700 • Fax 732-364-8110
www.componenthardware.com
