Author: JJ Contributors: Date: 3/17/2022 Revised:
TS- My Machine Won’t Hold a Charge
Troubleshooting Instructions
Step
Description
Tools
Picture
Models that Apply: Elite Liberty, 1, 2, 2.10, 3, 3.10, Pickle,
Pickle 2, Pickle 2.10
This guide applies when you try to charge your machine but
the battery does not seem to be holding a charge, or the
LED light on the charger is staying green even when
plugged into the wall outlet and the machine.
Step 1 – Check Reset Switch
1.
Check if the reset switch has been tripped.
If it is showing any white around the reset
button, press it back in and turn the
machine on.
2.
On Elite models (EL0L-EL03, Pickle &
Pickle 2) the reset switch is located on the
front of the control panel.
3.
(*
When tripped the Reset Switch will
expose 1/16
th
of an inch of white on its
underbelly).
If the reset switch is not tripped and the machine still
does not turn on then go to Step 2
Reset Switch (EL0L-EL03,
Pickle & Pickle 2)
Step 2- Checking the Charger
1.
Check the charger by plugging it into the
wall outlet (the LED on the charger itself
will light up green), and then connect it to
the XLR charging port on the machine.
If
the LED on the charger does not light
up, or is flashing either Red or Green,
then the charger is faulty, and needs
to be replaced.
The LED on the charger
should turn Red showing the battery is
charging. If the charger LED is still Green,
LED on charger Green light.
