15.19 Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
15.105 Information to user.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This product meets the government's requirements for exposure to radio waves. The guidelines are based on standards
that were developed by independent scientific organizations through periodic and thorough evaluation of scientific
studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of
age or health.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of
tissue. This device was tested for typical body-worn operations with the back of the handset kept 0mm from the body
and 25mm front of face. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a
0mm separation distance between the user's body and the back of the handset. The use of belt clips, holsters and
similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy
these requirements may not comply with FCC RF exposure requirements, and should be avoided.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum
separation distance of 0mm for body and 25 front of face worn must be mai
ntained between the user’s body, including
the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic
components. Body-worn accessories that do not meet these requirements may not comply with RF exposure
requirements and should be avoided. Use only the supplied or an approved antenna.
Battery Information
● The battery pack is not fully charged when purchased, pls charge it before first use.
● Do not short the battery to avoid damaging the battery, generating heat and causing a fire.
● Do not place the battery at high temperatures or throw it into a fire to avoid an explosion.
● If the battery is not used for a while, discharge it and store it in a dry, dark and cool place.
● Stop using the battery and cradle when it is damaged or significantly aged.
● Stop using the battery and charger when they are damaged or significantly aged.
● Return the used batteries to the supplier or to the designated collection point, not to household waste.
If the battery is damaged, avoid to touch the contents. If it gets contaminated with the skin, rinse it with plenty of water. If
necessary, ask for medical advice.
