R210
In order to take full advantage of your new product and enjoy long and trouble-free performance, please read this owner's manual
carefully, and keep it in a safe place for future reference.
1). Unpacking:
On unpacking your product please check carefully for any signs of damage that may have occurred whilst in transit
from the Laney factory to your dealer. In the unlikely event that there has been damage, please re-pack your unit in its original
carton and consult your dealer. We strongly advise you to keep your original transit carton, since in the unlikely event that your unit
should develop a fault, you will be able to return it to you dealer for rectification securely packed.
2). Amplifier Connection:
In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your
system. With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc, BEFORE
turing on your bass amplifier. Many products have large transient surges at turn on and off which can cause damage to your speakers.
By turning on your bass amplifier LAST and making sure its level control is set to a minimum, any transients from other equipment
should not reach your loud speakers. Wait till all system parts have stabillised, usually a couple of seconds. Similarly when turning off
your system always turn down the level controls on your bass amplifier and then turn off its power before turning off other
equipment
3). Cables:
Never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle
the amplifier load and could cause damage to your complete system.
4). Servicing:
The user should not attempt to service these products. Refer all servicing to qualified service personnel.
GENERAL INSTRUCTIONS
From amplifier
speaker socket.
To a second
Extension Cabinet.
=
200W RMS/400W Program
=
16 ohm impedance
=
2 x Speakon connectors
=
2 x10” custom designed drivers
=
HF Horn
=
Sensitivity: 98dB/W @ 1M
=
Frequency Range 50Hz - 4KHz
=
50Hz -20KHz with Horn
=
Black metal corners, comfortable grip top handle
=
Dual Rear Ports
=
H*W*D/mm: 438x579x403
=
Weight: 16.0Kg
HORN
LINK
INPUT
16
ON
OFF
POWER RATING:
200W RMS/400W PROGRAM
www.laney.co.uk
DESIGNED IN THE UK BY LANEY
MADE IN CHINA
The R210 Bass Enclosure features high quality drivers, rugged cabinet
construction, tough vinyl covering, protective metal corners and easy
lift handles to deal with the rigours of life on the road!
In addition to this, audio is hooked up via quality Input and Link
Speakon connectors located on the rear input plate which also
features an On/Off switch for the onboard HF horn. The R210 can be
used in both landscape & portrait modes.
Your Bass cabinet should give you years of trouble-free service,
however please take time to read this manual, as it will allow you to
get the best from your system.
ES
EN
