Lakeland Mills CF1128, Manual

Page: 1 / 4

CF1128/CFU28 CEDAR LOG YARD SWING
Please check contents before assembly. If any items are missing or damaged, do not take the unit back to the
store. Call 1-800-427-5136 for customer service and we will save you time by correcting any problems directly
for you.

Read all instructions before starting.

To start hex washer head screws, hammer into
wood about 1/2” then use wrench or socket to
tighten.

Do not completely tighten any screws until the
unit is fully assembled and setting on a level
surface.

Use a rubber mallet (or a block of wood be-
tween the hammer and the unit) to drive dow-
eled ends into holes as far as possible.
YARD SWING COMPONENTS
NOTE: Cracks or Checks in logs are part of the natural
beauty of cedar logs and should not be considered defects.
TOOLS REQUIRED
NOTE:
YARD SWING HARDWARE
(Shown smaller than actual size)
1 - Top Rail
2 - 24” Arms
Preassembled Swing Back
Preassembled Swing Seat
2 - 45”
Swing Bars
2 - Seat
Ends
Ten
Screws
Two 3/8” x 5”
Eye Bolts
Two Barrel
Nuts
Two 3/8”
Nuts
Four
1/4” x 5”
Hex Washer
Head Screw*
Six 3/8”
Washers
Two
3/8” x 8”
Bolts
Twelve
1/4” x 3”
Hex Washer
Head Screws*
Rubber
Mallet
Block of
Wood
& Hammer
Tape Measure
Regular
Screwdriver
or
Pencil
4 - Legs
6 - 34 3/4” Braces
Two 1/2” x 6”
Eye Bolts
Two 1/2”
Nylock Nuts
Four 1/2”
Washers
Two S
Hooks
2 - 12”
Arm Supports

3/4” deep well
socket

9/16” deep well
socket

9/16” wrench

7/16” socket or
wrench

3/8” socket or
#2
Philips
Screwdriver
* Hex Washer
Head Screws may
be substituted
with Lag Screws
and Washers.
Optional
NOTE: Using a battery or electric power drill with a
socket attachment will make assembly easier and
faster.