68559-001
Rev01
Kwilcset
SMART
CODE
,.
mm
TOUCHSCREEN ELECTRONIC DEADBOLT
Installation and User Guide
Required tools
mm , , , ,
c;;;;;g: -
4 AA Batteries
Ruler
Phillips head screwdriver
Additional Tools (depending on application)
,
�
Hammer
[) Wood block
a
Prepare the door and check dimensions
If drilling a new door, use the supplied template and the complete
door drilling instructions available at www.kwikset.com/doorprep.
A
Measure to confirm that the hole in
the door is either 2-1/8" (54 mm) or
1-1/2" (38 mm).
EJ
�
��
or
�
8
Note: Additional door preparation may be
required for doors with 1-1/2" (38 mm) holes.
Consult the deadbolt drilling instructions at
www.kwikset.com/doorprep.
Install the latch and strike
B
Measure to confirm that the backset is
either 2-3/8" or 2-3/4" (60 or 70 mm).
Parts in the box
Latch
Interior Assembly
Exterior Touchscreen
�A
"B" is not included. If needed,
please contact Kwikset to order
a drive-in latch for your lock.
Strike
Keys
c�
Traditional
Contemporary
M
K
Traditional
Fasteners
03809
N==
p==
Contemporary
46780
Q=
s ��::::
Adapter
Rlag
o
D
Mounting
Plate
�
:
SmartKey
Tool
I
O
11111111111111,,
I I
··
:
r·
;
·
G'
Q
0
C
Measure to confirm that the hole in
the door edge is 1" (25 mm).
0
1111111111111111111
l)ill)il
•••
D
Measure to confirm that the door is
between 1-3/8" and 2" (35 mm and
51 mm) thick.
1-3/8"-2"
35-51 mm
actual
size
�D��
ti
s
A
Is the door edge chiseled?
B
Hold the latch in front of the door hole, with the latch
face flush against the door edge.
D
Which latch are you installing?
YES
chiseled
Use latch "A". If the
latch bolt is not already
extended. extend the
latch bolt as shown.
NO
\J
0
not
chiseled
Use latch "B" (not
included). If the latch
bolt is not already
extended. extend the
latch bolt as shown.
C
Are the latch holes centered in the door hole?
No adjustment is required.
Proceed to next step.
1 / 4
Rotate latch face as
shown to extend latch.
�-
B
Latch"A"
NorP
(2x)
E
Install strike on the door frame.
Latch"B"
Lt
Make sure the hole in the door frame is drilled a
minimum of 1" (25 mm) deep.
Longer screws
install closest to
the door jamb.
S(2x)
door frame
