KFL-11P Visual Fault Locator Instructions for use
External and key function description
1
On/off button
3
Silicone cap
1
Ceramic ferrule
2
Open the dust cap and insert
the optical fiber interface under test
into the laser connector.
Product description
4
This product uses a 650nm semiconductor laser as a light-
emitting device and is driven by a constant current source to
emit stable red light; it enters a single-mode or multi-mode
fiber after being connected to an optical fiber interface to realize
the function of fiber fault detection. It is a fiber optic engineering
construction and a fiber optic network. An indispensable tool for
maintenance, optical device production and research.
Product features
5
650nm red laser.
Pulse and continuous wave operation.
Output power: 1MW, 10MW, 20MW, 30mw.
2.5 Universal connector.
30 hours operation (1MW).
1.25mm LC adapter (optional).
Metal Material.
Find fiber microbends, breaks and fiber damage.
1
3
4
2
Pilot lamp
Power on/off button
3
4
Laser connector
1
Long press ” ”to turn on, the red indicator
light will light up, and the laser will output continuous
wave at the same time;(If the fiber is connected, red
light can be seen at the end of the fiber under normal
circumstances; if the tested fiber is disconnected,
there is no red light output at the end of the fiber).
Shortly press the power button, the indicator
light flashes, and the laser pulse wave is output at
the same time; short press again to turn off the red
light.
Under normal circumstances, it will automatically
shut down if there is no operation for 15 minutes to
extend the battery life.
