1
Loosen the tension EVERY time you take a blade out,
before placing a new blade in
both blade clamps. It usually needs to be loosened several turns. However, do not let the barrel of the blade
holder slide off the red aluminum frame.
Tensioning
This shows what the black knurled knob is for. This is
how tensioning of the blade occurs. The knob must be
unwound each time to release tension. After clamping a
new blade, wind the knob to increase tension.
Check the Saw Blade length
Before sawing, check the length of the saw blades.
The standard length for jewelers saw blades is 5 1/8”
.
If the blades are too long, use wire cutters to shorten the blades.
Blades that are shorter than standard will not work. Return them to the source they were purchased from
as defective.
A C u t A b o v e
Using the Knew Concepts
Precision Saw Frame
with Advanced Screw
Tensioning
Tensioning knob
Blade clamping screw
V2.0
