STE-6012/6016 Room Temperature Transmitters
1
Installation Guide
Installation Guide
Room Temperature Transmitters (with LCD Display)
STE-6012/6016
Mounting
1
Location and Cover Removal 1
Handy Box Installation (Recommended)
1
Hollow Wall Installation 1
Wiring
2
STE-6016
2
STE-6012
2
Maintenance
2
More Information 2
Important Notices 2
Mounting
All dimensions are in inches
Handy Box Installation (Recommended)
1. Mount a universal
backplate HMO-6036 or
HMO-6036W to the handy
box using the two screws
provided.
2. Remove the cover from
the back panel.
3. Attach the back panel to
the backplate using the
two screws provided.
4. Attach the cable to the terminal block or jack
according to the appropriate wiring diagram on
the next page.
5. Replace the cover.
Hollow Wall Installation
1. Remove the cover from the back panel.
2. Using the back panel as a template, drill two holes
for mounting screws (7/64 inches or 3 mm in di-
ameter and 1.4 inches, 1-13/32 inches, or 35.6 mm
apart) and cut a center hole (size needed is depen-
dent on model) for the terminal block or jack.
3. Attach the back panel to the wall using two
#6 self-threading screws. (Plastic anchors are
recommended, and the size of the holes will then
need adjusting.)
4. Attach the cable to the terminal block or jack
according to the appropriate wiring diagram on
the next page.
5. Replace the cover.
Location and Cover Removal
Install the sensor on an inside wall where it can sense
the average room temperature and be away from
direct sunlight, heat sources, windows, air vents, and
air circulation obstructions (curtains, furniture, etc.). It
can be mounted on a hollow wall or (with a universal
backplate HMO-6036/ HMO-6036W) to a 2 x 4 inch
handy box.
The cover is held to the black, back panel by three,
small, round pegs that fit in the holes of the cover.
The bottom peg is on a tab and snaps into the center
bottom hole.
1. With a small Phillips screwdriver or hex wrench,
press in and hold the tab button that snaps into
the center hole on the bottom cover
.
2. Carefully pull or pry the back panel from the
front cover.
2.438
2.250
R 3.094
R 0.187
0.643
STE-6012
0.475
max.
STE-6016
Modular
RJ-45
Jack
Four-pin
EIA-485
PC Data
Port
Clamp
(Screw-type)
Terminals
0.149
Model
Number
Connections
Screw Clamp
Terminals
RJ-45
Connector
EIA-485 Data
Port
STE-6012-10
X
STE-6016-10
X
X
