KMC Controls CSP-4702, Installation Manual

Page: 1 / 4

CSP-4702 1 Installation Guide
Installation Guide
Analog Differential-Pressure VAV Controller/Actuator
CSP-4702
Mounting
Illustration 1—Overview (Direct-Coupled Mounting)
approximately 5° may provide tight
damper shut-off.
3. Align the actuator and slide it onto the shaft.
4. Leaving a small gap between the actuator and
mounting surface to prevent any binding, finger-
tighten the nuts on the V-bolt.
5. Insert the provided (HMO-4002) non-rotation
bracket into the slot at the base of the actuator
and secure the non-rotation bracket with two #8
or #10 self-tapping screws.
6. Evenly tighten the V-bolt nuts (30–35 in-lb.).
7. If desired, use a 7/64-inch hex key wrench to
loosen and position the end-stop screw.
NOTE: The two holes at the top of the actuator
are NOT for use in direct-coupled
applications. (They are for remote
mounting, such as with the optional HLO-
4001 Crank Arm Kit.)
NOTE: For VAV applications with the analog
CTE-5202 thermostat, see the CTE-5202
Applications Guide . For static pressure
controller applications, see the CSP-
4702 Static Pressure (Bypass) Control
Application Guide .
The CSP-4702 mounts directly to 1/4- to 5/8-inch (6 to
16 mm) round shafts or 1/4- to 7/16-inch (6 to 11 mm)
square shafts.
1. Ensure the damper can move freely through its
entire range of motion, and fix any binding before
installing the actuator. Turn the damper blade to
its fully closed position.
2. Press (to the right) and hold the gear disengage -
ment lever (see Illustration 1), rotate the actuator
to the fully closed position, and release the lever.
NOTE: Depending on the damper-seal design,
backing the actuator off its stop
HMO-4002
Non-Rotation
Bracket
Mounting
Surface
5.312
(134.9)
Adjustable Stop
Min/Max
Flow Limit
Meter Taps
Min/Max
Flow
Setting
Pots
Open &
Close
LEDs
2.50
(63.5)
2.812
(71.4)
2.60
(66.0)
Gear Disengagement Lever 1.563
(39.7)
∆
P Ports
Barbed
Connections
for 1/4" FR
Tubing
Removeable Conduit Fitting
with 1/2" NPS Threaded Hole
Mounting .........................................................................................................1
Wiring Connections .........................................................................................2
Rotation Direction ...........................................................................................2
Air Pressure Connection ...................................................................................2
Min. and Max. Flow Limits ...............................................................................3
Limits Set at the CSP-4702 ...........................................................................3
Limits Set at the Thermostat .........................................................................3
Operation Test ..................................................................................................3
Maintenance ....................................................................................................3
Troubleshooting ...............................................................................................4
No Rotation ..................................................................................................4
Wrong Rotation Direction or Stroke Range ..................................................4
No Pressure Output Signal ...........................................................................4
Wiring Issues ................................................................................................4
Static Pressure Control .....................................................................................4
More Information .............................................................................................4
Important Notices ............................................................................................4