�1campinQ
Kingfisher 4 Air
Recreational Tent
Model No. KC072-44 7
PITCHING INSTRUCTIONS
Your tent includes:
25 x steel pegs (5mm)
10 x ropes
1 hand pump
1. Select a dry, level site and
clear the ground of any sharp
objects. Remove the tent, pegs
and pump from the carry bag.
Unclip and unroll the tent.
2. Pitch so the tent is in line with
wind, never side on. Spread out
the tent and peg out the four
main corners ensuring the tent
is pulled taut and square. Then
peg out the remaining pegging
points.
3. Attach the pressure restrictor to
the hand pump. Locate the air
valves on the right-hand outer
side of the tent.
To make sure the tent
stays
in place
insert the pegs into the ground at a
45
°
angle, not straight down.
Filename: 5359 KC072-447 Kingfisher 4 Air Instructions
Dimensions: 410mm W x 220mm H
Colour: Black
'
\
I
Top Valve
Cap
4. There is an external valve located on each air tube. Before
inflating, the valves need to be screwed into the air tube.
5. Unscrew the top valve cap. Insert the pump hose into the
valve and inflate the air tubes from the centre tubes outwards.
You may need to help the tube stand up so it inflates evenly
and in the correct shape. Make sure you only inflate to the
recommended pressure (6-8psi) as over-inflation can lead to
tube damage. Screw the top valve cap back on after inflating
each air tube. Only use the pump provided as it has a pressure
gauge which shows the recommended pressure.
6. It is recommended in hot weather that 6psi is used to allow
for the air to expand inside the air tubes. In cooler/windier
conditions 8psi is recommended. Please adjust the pressure
in the air tubes as the ambient temperature changes. Only use
the pump provided as it has a pressure gauge which shows the
recommended pressure (psi).
7. Making sure the tent is sitting evenly, peg out the remaining
pegging points on the floor and ventilation ports. You may
need to adjust the base of each air pole so it sits flat with the
ground.
8. Rope out the guy ropes and fine tune the tent so it remains taut
and positioned correctly.
9. Please read the care instructions for more product information
about your tent.
REVERSE THE PROCEDURE TO LOWER THE TENT
PACKING INSTRUCTIONS
Unzip doors and windows. Pull out the pegs, leaving the four corner
pegs in. Unscrew the main valves and deflate the air tubes. Make sure
all the air escapes by forcing the air out toward the valves. Remove
the remaining pegs. Fold the tent as shown below, ensure that the air
valves are not obstructed to allow the remaining air to escape.
To reduce the chance of valve malfunction, the valves should be fully
unscrewed when the product is in storage.
Ensure the tent is completely dry and clean before storing away and
store it in a dry environment.
-
�
r\
r\
�/��/>
ill
[J
Lay flat
Fold once
Fold twice
Fold again
0
�
Roll
