1” Air Impact Gun Composite
1. Always follow the safety rules and instructions in this manual to avoid the risk of personal Injury
and property damage. It is absolutely necessary to study the operating manual before starting this
tool. Keep these instructions in a safe and accessible place.
2. Noise
Warning: Always wear approved ear protection at environmental noise levels >85 dB(A) due to risk of
impaired hearing.
3. Foreword
This hand-held air impact wrench consists simply of a motor connected to the drive spindle through
reduction gearing. Torque delivered by the tool is adjusted by regulating the pressure of the air
entering the motor. The operator applies the tool to the fastener, starts the motor and allows it to run
until the torque in the fastener builds up to the point where the motor stalls. This is a perfect tool
for tightening or loosing threaded fasteners in work areas such as that of a body and automotive
workshops, construction, light assembly in electrical, mining, marine... etc
4. General safety rules
Read all these safety instructions before operating this tool.
When using air impact wrenches, basic safety precautions, including the following, should always be
followed to reduce the risk of personal injury and damage to property.
The manufacturer will not accept any responsibility for injury or damage caused by improper use of this tool.
If you have any question, please contact our authorized representatives.
4.1 Before using the tool ensure you have full understanding of the tool's application and limitations,
as well as the specific hazards that apply to it.
4.2 Danger of explosion.
Never use oxygen and combustible gas as an air supply for the tool which may be ignited by sparks
and cause fire or explosion.
Only use filtered, lubricated, regulated compressed air.
4.3 Never use gasoline or other flammable liquids to clean the tool.
Vapor in the tool can be ignited by sparks and cause the tool to explode.
4.4 Keep work space clean.
The work area where the tool is used should be kept clean. An unclean work area is a potential
cause of accidents.
Other people should be kept away from the working area.
.
4.5 Consider the working area environment.
Do not expose air tools to rain or use them in damp or wet locations.
Keep the work area well lit.
Do not use air tools in the presence of flammable liquids or gases.
