GENERAL SAFETY INFORMATION
1. This service instruction sheet contains important warnings and other information.
READ & KEEP FOR REFERENCE
2. This product is designed and intended for use only with 10-30 Volts DC (ELV-Extra Low Voltage) such as that in a motor vehicle or other plant and machinery.
Applying voltages higher or lower than or at any voltage in AC (alternating current) form will result in damage to the light bar and possible harm or injury to the user.
3. Before wiring up this Light, Ensure the battery and any other power source to the vehicle is disconnected or isolated to prevent electric shock.
4. Do not look directly into the light when it is on. It may result in eye damage.
5. PLEASE CONTACT YOUR LOCAL REGULATORY BODIES FOR LEGALITIES ON THE ROAD.
6. Installation of this item must be carried out by a competent person who has acquired the skills through training, experience or a combination of these.
7. Failure to follow any part of these pages may result in premature failure of the light bar and possible damage or injury to property or persons.
8. The information in this manual has been carefully checked and is believed to be entirely reliable and consistent with the product described.
However, no responsibility is assumed for inaccuracies, or for liability arising out of the application and use of the equipment described.
9. Should the equipment be used in a manner not specified, the protection provided by the equipment may be impaired and the warranty voided.
UNPACKING
1. Unpack all the components from the box.
When unpacking the LED Bar light, carefully inspect for any damage that may have occurred during transit or storage.
Check for tears, loose parts, missing parts or damaged parts.
2. Ensure all packaging material are disposed of as per your local council guide lines.
SPECIFICATION:
Model No.
K10500
K10501
K10502
LED Power
180 Watts
234 Watts
306 Watts
Mounting Bracket
Adjustable Brackets x 3
Adjustable Brackets x3
Adjustable Brackets x 3
Ingress Protection Rating
IP67
IP67
IP67
No. 3W Cree LEDs
60
78
102
Colour Temperature
6000k
6000k
6000k
Housing Material
Diecast Aluminium
Diecast Aluminium
Diecast Aluminium
Lens Material
Polycarbonate
Polycarbonate
Polycarbonate
Beam
Spot 20°
Flood 40°
Flood 40° /Spot 20°
Life Span (hours)
30,000+
30,000+
30,000+
Light Output (Lumens)
15,300
19,890
26,010
Size
32 Inch
810x85x75mm
41 Inch
1040x85x75mm
50 Inch
1350x85x75mm
ASSEMBLY OF ADJUSTABLE MOUNTS
1. Turn the light bar upside down so you can see the slide track (fig 1).
2. One by one insert all the slider brackets into the track and slide each bracket along the track before inserting the next bracket (fig 2).
3. Position brackets where required and fasten with the provided hex screws (fig 3).
4. Insert eyelet bolt into the centre slot of the slider bracket (fig 4).
5. Feed the fastening bolt through the hole of the sliding bracket and eyelet bolt, assemble and tighten the spring washer and nut (do not over tighten) (fig 5).
6. Attach the adjustable locking plate at the desired position then fasten with spring washer and nut (fig 6).
7. Tighten all nuts, and mount where desired.
(fig 1)
(fig 2)
(fig 4)
(fig 3)
(fig 6)
(fig 5)
LED LIGHT BAR
3W CREE
