1
UNPACKING AND CHECKING EQUIPMENT
Note:
The following unpacking information is for use by your
KENWOOD
dealer, an authorized
KENWOOD
service center, or the
factory.
Carefully unpack the repeater. We recommend that you identify
the items listed in the following table before discarding the
packing material. If any items are missing or have been damaged
during shipment, fi le a claim with the carrier immediately.
Item
Part Number
Quantity
Front glass
B10-2781-XX
1
Dressed screw
N08-0563-XX
1
Bracket
J29-0725-XX
2
Flat head machine screw
N32-4008-XX
4
Handle
K01-0421-XX
1
DC cord
E30-3427-XX
1
Lead wire with connector (15 pin)
E31-3228-XX
1
Fuse (15 A)
F52-0042-XX
1
SYNC cable
E3A-0177-XX
1
Instruction manual
B5A-0714-XX
1
INSTALLATION
To install the handles onto the front panel of the repeater, align
the handles with the holes on the front panel, then secure the
handles using the supplied screws.
Consult your dealer for installing the repeater and antenna.
MICROPHONE
Connect an optional KMC-30, KMC-35, KMC-9C, or KMC-53
KENWOOD
microphone to the
MICROPHONE
jack on the front
panel.
OCXO UNIT (KXK-3): Option
The OCXO unit (KXK-3) is an Oven Controlled Crystal Oscillator
(OCXO) unit.
NOTICES TO THE USER
◆
Government law prohibits the operation of unlicensed radio
transmitters within the territories under government control.
◆
Illegal operation is punishable by fi ne and/or imprisonment.
◆
Refer service to qualifi ed technicians only.
◆
This repeater is intended for use as a fi xed base station with
the antenna located outdoors on the rooftop or on an antenna
tower.
◆
This repeater is designed for a 13.2 V DC power source.
Never use a 24 V DC or higher source to power the repeater.
◆
Use only the supplied DC cord.
◆
Do not remove the ferrite core attached to the DC cord. Doing
so may cause interference with radio communications.
◆
Do not put anything on top of the repeater. This will obstruct
heat dissipation.
THANK YOU!
We are grateful you purchased this
KENWOOD
repeater.
PRECAUTIONS
•
Do not expose the unit to rain or moisture; to prevent fi re or
electric shock.
•
Do not open the unit under any circumstances; to avoid risk
of electric shock.
•
Do not expose the unit to long periods of direct sunlight, nor
place it close to heating appliances.
•
Do not place the unit in excessively dusty and/or humid
areas, nor on unstable surfaces.
•
Do not put the plastic bag used for packing of this equipment
on the place which reaches a small child's hand. It will
become a cause of suffocation if it wears fl atly.
•
Always switch the transceiver power off before installing
optional accessories.
•
If you detect an abnormal odor or smoke coming from the
unit, disconnect the power from the unit immediately. Contact
your
KENWOOD
service center or dealer.
NOTIFICATION
This equipment complies with the essential requirements of Directive
1999/5/EC.
The use of the warning symbol
means the equipment is subject to
restrictions of use in certain countries.
This equipment requires a licence and is intended for use in the countries
as below.
AT
BE
DK
FI
FR
DE
GR
IS
IE
IT
LI
LU
NL
NO
PT
ES
SE
CH
GB
CY
CZ
EE
HU
LV
LT
MT
PL
SK
SI
BG
RO
HR
TR
ISO3166
B5A-0714-00 (E)
VHF DIGITAL BASE-REPEATER/ UHF DIGITAL BASE-REPEATER
INSTRUCTION MANUAL
NXR-5700/ NXR-5800
◆
Do not install the repeater in explosive atmospheres
(infl ammable gas, dust particles, metallic powders, grain
powders, etc.).
Hereby, JVCKENWOOD Nederland B.V. declares that the radio
equipment types in this instruction manual are in compliance with
Directive 1999/5/EC. The full text of the EU declaration of conformity
is available at the following internet address:
http://www.kenwood.com/cs/com/ecdoc/
(Note: The detail type designations are described in the EU
declaration of conformity.)
Firmware Copyrights
The title to and ownership of copyrights for fi rmware embedded in
KENWOOD product memories are reserved for JVC KENWOOD
Corporation.
Information on Disposal of Old Electrical and Electronic Equipment and Batteries
(applicable for countries that have adopted separate waste collection systems)
Products and batteries with the symbol (crossed-out wheeled bin)
cannot be disposed as household waste.
Old electrical and electronic equipment and batteries should be
recycled at a facility capable of handling these items and their waste
byproducts.
Contact your local authority for details in locating a recycle facility
nearest to you.
Proper recycling and waste disposal will help conserve resources
whilst preventing detrimental effects on our health and the environment.
© 2015
The AMBE+2
TM
voice coding Technology embodied in this product
is protected by intellectual property rights including patent rights,
copyrights and trade secrets of Digital Voice Systems, Inc. This
voice coding Technology is licensed solely for use within this
Communications Equipment. The user of this Technology is
explicitly prohibited from attempting to extract, remove, decompile,
reverse engineer, or disassemble the Object Code, or in any other
way convert the Object Code into a human-readable form. U.S.
Patent Nos. #6,199,037, #6,912,495, #8,200,497, #7,970,606, and
#8,359,197.
