Km35
Series
D
rinking
Fountains
/
Water
Coolers
INSTALLATION
,
CARE
&
USE
MANUAL
Page
1
(
Rev
.
A
-
6
/
2012
)
To insure you install these models easily and correctly, PLEASE READ THESE
SIMPLE INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK
YOUR INSTALLATION FOR COMPLIANCE WITH PLUMBING, ELECTRICAL, AND
OTHER APPLICABLE CODES. After installation, leave these instructions with the
Fountain for future reference.
IMPOR TANT
THIS
IS
AN
INDOOR
APPLICATION
ONLY
.
ALL
SERVICE
TO
BE
PERFORMED
BY
AN
AUTHORIZED
SERVICE
PERSON
.
IMPORTANT
!
INSTALLER
PLEASE
NOTE
.
THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES
IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE
BUILDING. THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK INTO A FOUNTAIN, CREATING AN ELEC-
TROLYSIS WHICH CAUSES A METALLIC TASTE OR AN INCREASE IN THE METAL CONTENT OF THE WATER.
THIS CONDITION IS AVOIDABLE BY USING THE PROPER MATERIALS AS INDICATED. ANY DRAIN FITTINGS
PROVIDED BY THE INSTALLER SHOULD BE MADE OF PLASTIC TO ELECTRICALLY ISOLATE THE FOUNTAIN
FROM THE BUILDING PLUMBING SYSTEM. WE SUGGEST THAT THE BOTTLE FILLING STATION AND WATER
COOLER BE PROTECTED BY A GROUND FAULT CIRCUIT INTERRUPTER (GFCI).
TOOLS
REQUIRED
BUT
NOT
PROVIDED
:
SAFETY
GLASSES
GLOVES
1-3/8"
HOLE
PUNCH
(
PROVIDED
)
1/2"
DRILL
BIT
ELECTRIC
DRILL
3/4"
WRENCH
OR
CRECENT
WRENCH
5/16"
NUT
DRIVER
UTILITY
KNIFE
TAPE
MEASURE
PENCIL
CENTER
PUNCH
1/2"
SOCKET
&
RATCHET
WRENCH
5/32"
ALLEN
WRENCH
KEMAO
R
