Stand 17.02.2016
Seite 1 von 12
Mounting Instructions 82021 Code-Combi K
1 General
These mounting instructions are the basis for the approval by ECBS, VdS installation of the lock to be performed
exclusively in accordance with these instructions.
Guidelines of the national certification bodies are to be considered and complied with in addition.
Use high quality alkaline/manganese monobloc batteries only. Low quality batteries may cause oxidation which results in a
functional failure of the lock..
Avoid residual crystalline moisture in the cabinet (e.g. from varnishing) to make sure that electrical contact areas are not
attacked.
Make sure that the ingress of dirt or detergents (e.g. remaining fillers or cold cleaners) is prevented.
Do not grease/oil the lock or key.
It is recommended, that unauthorized persons have no access to security sensitive parts of the lock, also the door of the
safe, where the lock is installed, is open.
2 Mounting instructions for lock and control unit
Lock mounting position
Bolt left
Bolt down
Bolt up
Bolt right
Any variation of the lock or key may result in functional trouble and must better not be done. All claims under guarantee and
warranty will expire in this case.
Lock fastening: Use of M6 steel socket head cap screws or BSW ¼" steel bolts. The length of engagement must
correspond to the applicable standards considering the thickness of the lock height (see Fig. 1).
Fig.1
22
,7
19
,7
