SRX210 Services Gateway Quick Start
Use the instructions in this quick start to help you connect the SRX210 Services
Gateway to your network. For details, see the SRX210 Services Gateway Hardware
Guide at
http://www.juniper.net/techpubs/en_US/release-independent/junos/information-products/p
athway-pages/srx-series/product/index.html.
SRX210 Services Gateway Front Panel
SRX210 Services Gateway Back Panel
SRX210 Services Gateway Models
The following models of SRX210 Services Gateways are available:
On the SRX210HE2-POE model, Power over Ethernet (PoE) of 50 watts is supported
across four ports (
0/0
,
0/1
,
0/2
, and
0/3
).
Note that you must use the following power supply adapters (supplied) for your services
gateway:
54V, 200 watts power supply adapters for the PoE model
12V, 60 watts power supply adapters for the non-PoE model
Connecting and Configuring the SRX Series Device
Use the instructions below to connect and set up the SRX210 Services Gateway to
protect your network. Refer to the LEDs on the front of the device to help you determine
the status of the device.
Overview
The SRX210 Services Gateway requires these basic configuration settings to function
properly:
Interfaces must be assigned IP addresses.
Interfaces must be bound to zones.
Policies must be configured between zones to permit or deny traffic.
Source NAT rules must be set.
The device has the following default configuration set when you power it on for the first
time. To use the device, you do not need to perform any initial configuration.
Factory-Default Settings:
Callout
Description
Callout
Description
1
Mini-PIM slot
5
USB ports
2
Power button
6
Console port
3
LEDs: ALARM, POWER, STATUS,
HA, mPIM, EXPCARD
7
Gigabit Ethernet (
0/0
and
0/1
) and Fast
Ethernet (
0/2
to
0/7
) ports
4
RESET CONFIG button
Callout
Description
Callout
Description
1
Power supply input
4
Lock for security cable
2
Cable tie holder
5
ExpressCard slot
3
Grounding point
g031
132
1
5
6
7
2
3
4
g031
113
5
2
3
4
1
Device
DDR Memory
NAND Flash Memory
SRX210HE2
2 GB
2 GB
SRX210HE2-POE
2 GB
2 GB
Port Label
Interface
Security Zone
DHCP State
IP Address
0/0
ge-0/0/0
untrust
client
unassigned
0/1
and
0/2
to
0/7
ge-0/0/1 and
fe-0/0/2 to
fe-0/0/7
trust
server
192.168.1.1/24
