UNISUB®
Color Product Solutions
For use with Product # UN5758 / UN5581 / UN1015 / UN1027 /
UN1028 / UN5549 / UN5627 / 5659 / UN5724 / UN5823 / UN5947
No tools necessary.
Clock Movement Mounting Instructions
• Remove the protective film and sublimate the THB Tray Bottom. Since these parts are
of a larger surface area than you may be accustomed to, we recommend a 90 sec. hold
time @ 400° F with firm clamp pressure.
• Please exercise extreme caution when removing the THB from your heat press. Using
an oven mitt or rag when removing any items from your heat press is recommended.
• Warping can be minimized by allowing the board to cool face down on a flat, firm
surface with a flat weighted object on the back of the board. If warping is severe, the
board can be heated again on the backside for 20 seconds and allowed to cool as
described above.
• Pre assemble one End Rail and the two Side Rails. This is best done by installing the
2 screws on each side 1/2 way only. If the end piece is left loose, it will be easier to slide
the bottom into place. In doing so, the bottom becomes the guide that aligns the two
side rails to the end rail.
• Slide the sublimated base into the slots of the side rails first and end piece second.
The amount of warp in the tray bottom, the relationship of the slots in Side Rails and
End Rail and the accuracy of the assembly holes can all lead to slight difficulties in
assembling. Loosening one or both of the screws slightly may help in aligning the
components.
• With the Tray bottom, two side rails and the one end rail in place, the 4 screws on the
first End Rail can be tightened until the screw head is almost flush.
