Page
1
of
6
4/27/2006
© 2006 Global VR, Inc. All Rights Reserved. VORTEK, GLOBAL VR, and the GLOBAL VR logo are trademarks or registered trademarks of
Global VR, Inc. All other trademarks are the properties of their respective owners.
Installing a Jaton Video Card in VORTEK™
Document Part #: 040-0117-01
GLOBAL VR
®
is now shipping the Jaton 3DForce2 MX-64DDR video card as a replacement part
for use in VORTEK cabinets. This video card requires drivers that are supplied on the
Invasion
Earth
Game Software CD, or a separate VORTEK video driver CD. Follow the steps in this
document to install the video card and drivers. Install video drivers
only
from disks supplied by
GLOBAL VR.
Important:
Only install GLOBAL VR approved video cards in GLOBAL VR games. The games
will not run properly with other video cards.
Safety
Please read this page before beginning the service procedure.
To avoid electrical shock, disconnect the AC power cord before
beginning any service or installation procedures.
GLOBAL VR assumes no liability for any damages or injuries incurred
while setting up or servicing the cabinet. Only qualified service
personnel should perform installation or service procedures!
To prevent electrostatic discharge (ESD) damage, handle PCBs by the
edges only and use a grounding wrist strap or similar precaution.
Tools Required
•
Medium (#2) Philips Screwdriver
•
Grounding Wrist Strap (for ESD Protection)
Figure 1. Jaton 3DForce2 MX-64DDR Video Card
