Jason International, Inc. •
501.771.4477
Page 1 of 9
Customer Service : 800.255.5766
Copyright © 2016 Jason International.
49-1016-001
Date 10/16
OWNER’S MANUAL
Vivere
™
Collection Walk-In Baths
INSTALLATION, OPERATION, AND MAINTENANCE
OWNER’S RECORD
Dealer:
Date Purchased:
Date Installed:
Installer:
PLACE SERIAL NUMBER CARD WITH
PRODUCT CONFIGURATION IN THIS BOX
INSPECTION
Inspect the MicroSilk
®
Demonstration System prior to
installation. In the event of a problem, DO NOT install
the demonstration system.
All components are factory assembled to the system and
the system is water tested and inspected prior to leaving
Jason International, Inc.
NOTE:
Transportation and insurance from Jason’s
factory are the showroom’s responsibility.
Damage sustained in transit is the responsibility of
the carrier.
If damage is discovered, the carrier must
be immediately notified in writing with a request for a
representative to inspect the unit. Failure of the carrier
to respond should be reported to the seller and carrier.
Always file a freight claim promptly.
If the carton shows any sign of damage,
thoroughly inspect the product before accepting
and describe the problem on the Bill of Lading.
The installer is responsible for insuring that the unit is
free from defects or shipping damage.
In the event of a
problem, DO NOT install the demonstration system.
Jason International is not responsible for damage that
might have been avoided by inspection or testing prior to
installation.
Damage to the unit during installation will not be covered
by warranty and is the responsibility of the installer.
ALL WARRANTY CLAIMS ON ACRYLIC SURFACE
DAMAGE MUST BE MADE PRIOR TO INSTALLATION.
Inspect plumbing and bath surface for missing or damaged
components. Alert your dealer of any discrepancies.
To protect the unit from damage keep the bath in the
carton until ready for installation
“TO BE REMOVED FOR USE BY THE OCCUPANT.”
Jason International, Inc.
8328 MacArthur Drive
North Little Rock, AR 72118
www.jasoninternational.com
MADE IN THE U.S.A.
