![background image](http://html2.mh-extra.com/html/jason-hydrotherapy/integrity-a6060/integrity-a6060_installation-operation-and-maintenance-manual_3550650001.webp)
Jason International, Inc. •
501.771.4477
Page 1 of 9
Customer Service : 800.255.5766
Copyright © 2011 Jason International.
Owner’s Manual
Integrity
®
airMasseur
®
Baths
InsTallaTIOn, OPeraTIOn, anD MaInTenanCe
“TO BE REMOVED FOR USE BY THE OCCUPANT.”
49-1013-200
Date 04/11
Jason International, Inc.
8328 MacArthur Drive
North Little Rock, AR 72118
www.jasoninternational.com
OWNER’S RECORD
Dealer:
Date Purchased:
Date Installed:
Installer:
PlaCE SERIal NumbER CaRD WIth
PRODuCt CONfIguRatION IN thIS bOx
CautION: DO NOt lIft OR haNDlE thE bath bY ItS PlumbINg.
INSPECtION
Inspect the unit prior to installation. In the event of a
problem, DO NOT install the unit.
All components are factory assembled to the bath and the
unit is water tested and inspected prior to leaving Jason
International, Inc.
If the carton shows sign of damage, inspect the product
before accepting and describe the problem on the Bill of
Lading.
NOTe: Transportation and insurance from Jason’s
factory are the buyer’s responsibility.
Damage sustained in transit is the responsibility of the
carrier.
If damage is discovered,
If the carton shows sign of damage, inspect
the product before accepting and describe the
problem on the bill of lading.
the carrier must be immediately notified in writing with a
request for a representative to inspect the unit. Failure of
the carrier to respond should be reported to the seller and
carrier. Always file a freight claim promptly.
The installer is responsible for insuring that the unit is
free from defects or shipping damage. In the event of a
problem, DO NOT install the unit.
Jason International is not responsible for damage that
might have been avoided by inspection or testing prior to
installation.
Damage to the unit during installation will not be covered
by warranty and is the responsibility of the installer. ALL
WARRANTY CLAIMS ON ACRYLIC SURFACE DAMAGE
MUST BE MADE PRIOR TO INSTALLATION. Inspect
plumbing and bath surface for missing or damaged
components. Alert your dealer of any discrepancies.
To protect the unit from damage keep the bath in the
carton until ready for installation.