REMOTE MR 400 INSTALLATION
STEPS TO INSTALL A REMOTE MR 400
STEP 1: PLACING BOTH UNITS (REMOTE CONDENSER AND SPLIT MACHINE) IN ITS LOCATION
CHECKING THE PROPER CONNECTIONS FOR EACH UNIT:
REMOTE CONDENSER:
It needs an electrical supply (check label with power supply specifications). It comes
without an electrical cable. Connect to the power supply directly (it does not need
communication with the split unit).
To connect, remove the rear cover, using a Torx screwdriver. The electrical cable must
go through the hole next to the piping hole. Use a 3x1.5 mm
2
electrical cable.
Terminal connector to supply electrical power to the remote condenser, located behind the
metallic cover.
Level the unit correctly.
Locate the remote condenser unit under a shadow. We advise to place it under a roof,
whenever possible.
The remote condenser unit works between 0ºC (32ºF) and 43ºC (109.4ºF) air
temperature.
Terminal connector
Cable
passing hole
